Motorola CPCI-6020 manual Before You Install or Remove a Board

Before You Install or Remove a Board Hardware Preparation and Installation

4.Slide the CompactFlash memory card into the J15 connector and make sure that pin 1 of the card aligns with pin 1 of J15.

Insert CompactFlash

5.If you are installing RAM500 memory cards or a PMC module on this board, follow the installation instructions in Chapter 6, RAM500 Memory Expansion Module, on page 117 and PMC Module Installation on page 44. If not, read the next section nad then reinstall the CPCI-6020 assembly in the proper card slot. Check that the board is properly seated in the backplane connectors. Take care not to damage or bend connector pins.

2.12Before You Install or Remove a Board

Boards may be damaged if improperly installed or handled. Please read and follow the guidelines in this section to protect your equipment.

Damage of Circuits

Electrostatic discharge and incorrect board installation and removal can damage circuits or shorten their life

Before touching the board or electronic components make sure that you are working in an ESD-safe environment.

CPCI-6020 CompactPCI Single Board Computer Installation and Use (6806800A51C) 47