Motorola CPCI-6020 manual PMC Module Installation, Procedure

Hardware Preparation and Installation PMC Module Installation

Should it be necessary to install a PMC mezzanine on the baseboard, refer to PMC Module Installation in this chapter for a description of that installation procedure.

Damage of Circuits

Electrostatic discharge and incorrect module installation and removal can damage circuits or shorten their life.

Before touching the module or electronic components, make sure that you are working in an ESD-safe environment.

2.10PMC Module Installation

Procedure

The PCI mezzanine card (PMC) module mounts beside the RAM500 mezzanine on top of the CPCI-6020 baseboard. To install a PMC module, proceed as follows:

1.Attach an ESD strap to your wrist. Attach the other end of the ESD strap to the chassis as a ground. The ESD strap must be secured to your wrist and to ground throughout the procedure.

2.If the PMC module is being installed in a non-hot swap chassis, perform an operating system shutdown. Turn the AC or DC power off and remove the AC cord or DC power lines from the system. Remove the chassis or system cover(s) as necessary for access to the CompactPCI.

Product Damage

Inserting or removing PMC modules with power applied may result in damage to module components.

Before installing or removing additional devices or modules, read the documentation that came with the product.

Personal Injury or Death

Dangerous voltages capable of causing death exist.

To prevent injury, use extreme caution when handling, testing and adjusting this equipment.

44 CPCI-6020 CompactPCI Single Board Computer Installation and Use (6806800A51C)