Motorola CPCI-6020 Floppy Port Header, 8 +5VDC Power Connector, Floppy Header Pin Assignments

Transition Module Preparation and InstallationFloppy Port Header

Table 7-9 EIDE Header Pin Assignments (continued)

Pin	Signal	Signal	Pin
39	No Connect	GND	40

7.9.7Floppy Port Header

The CPCI-6020-MCPTM-01 provides a 34-pin header to interface to a floppy disk drive. The pin assignments and signal mnemonics for this connector are listed below.

Table 7-10 Floppy Header Pin Assignments

Pin	Signal	Signal	Pin
1	GND	No Connect	2
3	GND	No Connect	4
5	GND	No Connect	6
7	No Connect	INDEX_L	8
9	GND	MTR0_L	10
11	GND	DS1_L	12
13	No Connect	DS0_L	14
15	GND	MTR1_L	16
17	No Connect	DIR_L	18
19	GND	STEP_L	20
21	GND	WDATA_L	22
23	GND	WGATE_L	24
25	GND	TR0_L	26
27	GND	WPROT_L	28
29	GND	RDATA_L	30
31	GND	HDSEL_L	32

7.9.8+5VDC Power Connector

The CPCI-6020-MCPTM-01 has a 4-pin header that can be used to provide +5VDC power to off-board devices. This power is derived from the fused +5VDC power on the CPCI-6020- MCPTM-01. Any external device powered from this connector must draw no more than 200mA. The pin assignments are listed in the following table.

Table 7-11 +5Vdc Power Connector

Pin

1

2

3

Signal

+5 VDC Fused

GND

GND

148 CPCI-6020 CompactPCI Single Board Computer Installation and Use (6806800A51C)