Motorola CPCI-6020 Connectors and Cables, Rear Transition Module Connectors/Headers, COM3/COM4

Connectors and Cables Transition Module Preparation and Installation

Removal Procedure

Although the CPCI-6020 Single Board Computer can be removed and inserted while power is applied, the CPCI-6020-MCPTM-01 transition module is not hot swap capable. Inserting or removing the transition module while the CPU board is active may affect the normal operation of the CPU board. Even in a hot swap capable chassis, the CPU back end power should be switched off (or the chassis power shut down) prior to inserting or removing the corresponding transition module.

Follow these steps to remove the transition module from the rear chassis slot.

1.Remove the back-end power from the CPCI-6020 or power down the chassis.

2.Remove the system or chassis covers.

3.Loosen the screws that attach the transition module to the rear slot.

4.Push the ejector handles outward to the open position; this should disengage the connector from the backplane.

5.Using the handles, pull the module from the slot.

7.8Connectors and Cables

The connectors on the CPCI-6020-MCPTM-01transition module are listed in the next table. The port connectors are located on the front panel and the top side of the transition module, which is shown in Figure 7-2. Refer to Table 7-3 on page 142 for a list of the cables and Connector Pin Assignments on page 143 for connector pinout information.

Table 7-2 Rear Transition Module Connectors/Headers

	Type	Number	Description
	COM3/COM4	J1	50-pin female connector
	Ethernet Port 2	J2	Standard RJ-45 female connector
	CompactPCI	J3/J4/J5	J3 is a 95-pin AMP Z-pack 2 mm hard metric type B
			connector, J4 is a 110-pin 2 mm hard metric type B connector.
	Ethernet Port 1	J6	Standard RJ-45 female connector
	Serial Port 1	J7	Standard RJ-45 female connector
	Serial Port 2	J8	COM2 9-pin header
	EIDE Interface	J9	40-pin header for secondary EIDE port
	PIM Connector	J10/J14	Two 64-pin connectors for PMCIO (1 ground provided with
			each PMCIO signal)
	Floppy Header	J11	34-pin header for floppy port
	SIM Connector	J12/J13	Two 60-pin female connectors for SIMs
	Keyboard/ Mouse	J15	6-pin circular DIN for combined keyboard/mouse
	Connector
	Serial Port 3	J16	3-pin header for selection of DTE or DCE interface
CPCI-6020 CompactPCI Single Board Computer Installation and Use (6806800A51C)				141