Motorola CPCI-6020 manual CompactFlash Memory Card Installation

Hardware Preparation and Installation CompactFlash Memory Card Installation

2.11CompactFlash Memory Card Installation

Procedure

The CompactFlash memory card mounts on the CPCI-6020 baseboard. To upgrade or install a CompactFlash memory card, refer to the next figure and proceed as follows:

1.Attach an ESD strap to your wrist. Attach the other end of the strap to the chassis (for proper grounding). The ESD strap must be secured to your wrist and to chassis ground throughout the procedure.

2.If you are installing the board in a non-hot swap chassis, perform an operating system shutdown. Turn the AC or DC power off and remove the AC cord or DC power lines from the system. Remove the chassis or system cover(s) as necessary to access the compact PCI module.

Board Damage

Inserting or removing modules that are not HA capable with power applied may result in damage to module components.

Verify that your board is HA capable.

Personal Injury

Dangerous voltages capable of causing death exist.

To prevent injury, use extreme caution when handling, testing and adjusting this equipment.

3.Carefully remove the CPCI-6020 from the CompactPCI card slot and place it on a clean and adequately protected working surface with connectors J1 through J5 facing you.

Product Damage

Avoid touching areas of integrated circuitry; static discharge can damage these circuits.

Before touching the board or electronic components, make sure you are working in an ESD-safe environment.

46 CPCI-6020 CompactPCI Single Board Computer Installation and Use (6806800A51C)