Motorola CPCI-6020 manual Overview of Start-up Procedure, Startup Overview

Hardware Preparation and Installation Overview of Start-up Procedure

Shipment Inspection

To inspect the shipment, perform the following steps:

1.Verify that you have received all items of your shipment.

2.Check for damage and report any damage or differences to customer service.

3.Remove the desiccant bag shipped together with the board and dispose of it according to your country’s legislation.

The product is thoroughly inspected before shipment. If any damage occurred during transportation or any items are missing, contact customer service immediately.

2.3Overview of Start-up Procedure

The following table lists the things you will need to do before you can use this board and tells you where to find the information you need to perform each step. Be sure to read this entire chapter, including all Caution and Warning notes, before you begin.

Table 2-1 Startup Overview

	Task	Page
	Unpack the hardware.	Chapter 2, Unpacking and Inspecting the Board, on
		page 35
	Configure the hardware by setting jumpers	Chapter 2, Jumper Settings, on page 41
	on the boards.
	Ensure CompactFlash card is installed (if	Chapter 2, CompactFlash Memory Card Installation,
	required).	on page 46
	Ensure memory mezzanines are properly	Chapter 6, RAM500 Module Installation, on page 118
	installed on the board.
	Install PMC Module	Chapter 2, PMC Module Installation, on page 44
	(if required).
	Install the CPCI-6020 in the chassis.	Chapter 2, Installing and Removing a Module, on page
		51
	Install PIM on CPCI-6020-MCPTM-01	Chapter 7, Installing the PIM, on page 138
	(if required)
	Install peripherals, and any other devices or	Appendix A, Manufacturers’ Documents, on page 161
	equipment used.
	Power up the system.	Chapter 2, Hardware Preparation and Installation
	Ensure that the debugger initializes the	Chapter 5, Firmware
	CPCI-6020
36	CPCI-6020 CompactPCI Single Board Computer Installation and Use (6806800A51C)