1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
10
3 GETTING ACQUAINTED
REAR PANEL
qq
qq
qANT 1 and ANT 2 connectors
Connect the feed lines from your antennas to these
connectors. Refer to pages 1 and 48 for details.
ww
ww
wAT connector
Mates with the connector on the cable supplied with the
external antenna tuner. Refer to the instruction manual
supplied with this tuner for more information.
ee
ee
eDC 13.8 V power input connector
Connect a 13.8 V DC power source {page 2}. Use the
supplied cable with a regulated DC power supply.
rr
rr
rGND post
Connect a heavy gauge wire or copper strap between
the ground post and the nearest earth ground {page 2}.
tt
tt
tCOM connector
Mates with a 9-pin female RS-232C connector for
connecting a computer via one of its serial
communication ports {page 60}. Also used with the
Quick Data Transfer function {page 60}.
yy
yy
yKEY and PADDLE jacks
The PADDLE jack mates with a 6.0 mm (1/4")
3-conductor plug for connecting a keyer paddle to the
internal electronic keyer. The KEY jack mates with a
3.5 mm (1/8") 2-conductor plug for connecting an
external key for CW operation. Read “Keys and
Keyboards for CW Operation” {page 3} before
connecting to these jacks.
uu
uu
uACC 2 connector
Mates with a 13-pin male DIN connector for connecting
various accessory equipment {pages 61, 62}.
ii
ii
iEXT SP jack
Mates with a 3.5 mm (1/8"), 2-conductor (mono) plug for
connecting an external speaker {page 3}. Connecting
an external speaker cuts off the audio automatically to
the internal speaker.
oo
oo
oREMOTE connector
Mates with a 7-pin male DIN connector for connecting a
linear amplifier {page 61}.
European versions only: Before connecting to the ACC 2 and
COM connectors, remove the protective covers.
ANT 2
AT
DC 13.8V
GND
EXT.SP
8ΩREMOTE
ANT 1
KEY
COM PADDLE ACC 2
o
we
r
tyui
q