i n t e l l i g e n t w i r e l e s s | p l a t f o r m |
2.6. Changing from Router to NAT Mode
Follow the steps below to change the airClient TOTAL from Router Mode to NAT Mode:
1.From the navigation menu bar, click on Tools System Configuration. The System Configuration screen will appear as shown below.
2.Under the Current Operational Mode, choose the operation mode NAT.
3.Click on Save to reboot the unit and convert to NAT mode.
4.The IP Address, IP Mask and Gateway for Ethernet Configuration and Wireless Configuration remains the same in the NAT mode as it was in the Router mode.
Figure 2-8 Changing Router Mode to NAT Mode
2.7. Changing from Router/NAT to Bridge Mode (sB3416-03 Only)
This section is only valid for the
1.From the navigation menu bar, click on Tools System Configuration. The System Configuration screen will appear as shown below.
airClient™ TOTAL 3416 User Guide | Page 22 of 74 |
|