SmartBridges sB3416-01, sB3416-02 manual airClient Total Bridge LAN Settings sB3416-03 Only

Page 30

i n t e l l i g e n t w i r e l e s s

p l a t f o r m

LAN Settings

This section outlines the procedures for changing the IP settings for bridge mode. These settings are the same in all possible bridge modes –

1.From the navigation menu bar, click on Home LAN Settings to change IP address and mask of the unit in bridge mode. The LAN Settings screen will appear as shown below in Fig 2-16.

2.Enter the System Name of the unit, if needed.

3.Enter the IP address and Subnet mask to set the IP address and subnet mask, and any Gateway Address if required. Assign the unit a unique IP Address in the designated IP subnet.

4.Click on Save to save the changes. The settings will be applied after the reboot.

Figure 2-16 airClient TOTAL Bridge LAN Settings (sB3416-03 Only)

Radio Settings

Follow the steps below to configure the Radio parameters in the airClient TOTAL Bridge Mode, for Non- Transparent bridging :

1.From the navigation menu bar, click on Radio Wireless Settings to set the radio parameters. The Wireless Settings screen will be displayed as shown in Fig 2-17.

2.Set the SSID, and the wireless mode to 801.11a.

3.The Remote AP MAC Address should be set to 00:00:00:00:00:00.

4.The Channel field will be set to SmartSelect in this mode. (Note: The channel is not configurable in this mode, and will follow the channel of the Access Point, it is associated with.)

5.For the Antenna Selection, choose either Internal or External antenna, as per the requirement.

6.Select the Country for the domain settings.

7.Configure the Distance parameter to configure the Ack Window.

8.Select the Data Rate from the drop down menu. By default, the data rate is set to Best.

airClient™ TOTAL 3416 User Guide	Page 30 of 74

Image 30

Contents AirClient Total 551 Series VersionContents Appendix a Some Useful Terms and Definitions Congratulations on your purchase of sB product Overview of User GuideRelated Publications Technical Support CenterIntroduction System RequirementsChecklists Pre-Installation Checklist for airClient TotalParameters Units Site a Site B Signature of EngineerPost-Installation Checklist for airClient Total Name DateChecklist Parameters Units Site a Site B Administrator Login and License Agreement AirClient Total Administrator LoginAirClient Total License Agreement AirClient Total 3416 User Guide Wireless LAN SettingsSettings SettingWeb GUI Administrator User Name and Password Change AirClient Total Administrator User Name/Password ChangeUsing the Configuration Pages Description of Menus Menu Item Menu Sub-itemsHome Security Menu Item Menu Sub-items DescriptionNetworking Radio Open System / Shared KeyTools Help LogoutDevice Mode Configuration AirClient Total Device Mode ConfigurationChanging from NAT to Router Mode Changing NAT Mode to Router ModeChanging from Router to NAT Mode Changing from Router/NAT to Bridge Mode sB3416-03 OnlyChanging from Bridge to Router/NAT Mode sB3416-03 Only Changing Router/NAT Mode to Bridge Mode sB3416-03 only10 Changing Bridge Mode to Router or NAT Mode sB3416-03 Only AirClient Total Bridge Configuration sB3416-03 only System ConfigurationWDS Bridge Mode LAN Settings Radio Settings 14a airClient Total Summary Information Client Bridge Mode Non-WDS Non-Transparent Bridging MAC TranslationLAN Settings 16 airClient Total Bridge LAN Settings sB3416-03 OnlyT e l l i g e n t w i r e l e s s A t f o r m Transparent Bridging Single MAC Only 19 airClient Total Bridge LAN Settings sB3416-03 Only T e l l i g e n t w i r e l e s s A t f o r m AirClient Total Router / NAT Configuration 21 airClient Total Router/NAT LAN SettingsWlan Settings Set the Primary/Secondary DNS Server, as requiredT e l l i g e n t w i r e l e s s A t f o r m T e l l i g e n t w i r e l e s s A t f o r m 24 airClient Total Router Wireless Settings 25c airClient Total Association Status Graph Dhcp Configurations 26 airClient Total Dhcp Server Configurations Dhcp Relay Configuration 28 Disable Dhcp and Dhcp Relay29 airClient Total Dhcp Relay Configuration 10.5. IP/Port Forwarding30 airClient Total IP/Port Forwarding Table Routing Table 32 Editing IP/Port Forwarding Table Entry33 airClient Total Add Static Route in Routing Table 35 Deleting the Static Route Security Open System / Shared KeyWPA-PSK Passphrase CipherWireless Settings Transmit Power Wireless ModeDefault Data Rate Protection ModeWireless Bandwidth Control Bandwidth ControlAirClient Total Wireless Bandwidth Control sB3416-03 Ethernet Bandwidth Control sB3416-03 onlyT e l l i g e n t w i r e l e s s A t f o r m T e l l i g e n t w i r e l e s s A t f o r m T e l l i g e n t w i r e l e s s A t f o r m Broadcast Packets Receive Wireless Traffic Statistics Total Bytes ReceiveTotal Bytes Transmit Broadcast Packets TransmitSystem Configuration AirClient Total System ConfigurationSntp Setting System Admin Site SurveySnmp Configuration System UserBackup/Restore Settings AirClient Total Snmp ConfigurationFirmware Upgrade AirClient Total Backup/Restore SettingsAirClient Total Firmware Upgrade Product License Key 10 airClient Total Product License Key InputLink Budget Planning 11 airClient Total Link Budget Planning GPS Calculator12 airClient Total Link Budget Planning Calculator System Log 13 airClient Total System LogReboot 14 airClient Total Reboot15 airClient Total Reboot Appendix a Some useful terms and definitions Acronyms and AbbreviationsCofdm