i n t e l l i g e n t w i r e l e s s | p l a t f o r m |
The following table summarizes the information for the System Configuration page.
|
|
| Table |
|
|
|
|
| Page Item |
| Descriptions. |
| System Name |
| Name of the airClient TOTAL. |
| SNMP |
| This field links to the SNMP Configuration page settings. |
| Configuration |
| |
|
|
| |
| Reset |
| This button Resets the airClient TOTAL unit. A message box is prompted to the |
|
| user to confirm the reboot. | |
|
|
| |
| SNTP Server |
| Allows user to set the Network Time Server and Time Zone |
| Firmware Version |
| The version of the firmware installed on the unit currently. |
| Local MAC |
| The MAC Address of the local airClient TOTAL unit. |
| Address |
| |
|
|
| |
| Reset to Factory |
| This button resets the unit to the factory default settings. A message box is |
| Defaults |
| prompted to the user to confirm resetting the unit to factory defaults. |
| Ethernet MTU Size |
| Displays the Ethernet MTU size. |
| System Log |
| This links to the System Log page settings. |
| Current |
| Displays the operating mode of the unit. |
|
| This could be Router or NAT for | |
| Operational Mode |
| |
|
| This could be Bridge or Router or NAT for | |
|
|
|
5.2. SNTP Setting
The device time comes from the network time information source. The device needs access to a network timer (NTP time server) source. The NTP time server IP can be configured as follows:
1.From the navigation menu bar, click on Tools SNTP Setting to configure the NTP Server. A page as shown below will appear.
2.Enter a valid SNTP server IP address and select the Time Zone. The default NTP server is 128.250.36.2 and the default Time Zone is Singapore.
3.Click on the Save button to configure the NTP.
4.After the Save/Reboot, the network time will appear on the browser, if the NTP server is contactable.
Figure 5.2 airClient TOTAL SNTP Time Settings |
|
airClient™ TOTAL 3416 User Guide | Page 61 of 74 |
|