SmartBridges sB3210 manual AirPoint Configuration, User Login and License Agreement

Page 10

i n t e l l i g e n t

w i r e l e s s

p l a t f o r m

2. airPoint™ Configuration

This chapter explains how to log in, change passwords and configure the various parameters for the airPoint™ Nexus.

2.1. User Login and License Agreement

The airPoint unit comes with a pre-configured default Ethernet (wired-side) IP address: 192.168.0.206

and subnet mask: 255.255.255.0.This default device IP address should be used to access the device configuration management interface from any web-browser (Enter http://192.168.0.206 for the URL address). In addition, the Sun Java Plug-in should be installed. The PC must be on the same subnet as the airPoint™ unit.

Follow the steps below to login as an Administrator to the web-based configuration management interface system:

1.Connect the airPoint™ unit via the ETH A/ETH B port to a PC.

2.Open a web browser on the PC.

3.Enter the device IP address 192.168.0.206 in the web browser address field and press the Enter key.

4.A user login box will appear. Enter the ’User name’ and ’Password’ and check the ’Remember my password’ checkbox if you want the system to remember the password. The default User name is Administrator and the password is smartBridges (case sensitive).

Figure 2-1 User log in box

5.Click the ’OK’ button

6.A License agreement page will appear. Click ‘Accept’.

airPoint™ Nexus User Configuration Guide	Page 10 of 55

Image 10

Contents AirPoint Nexus SB3210 VersionTable of Contents Overview of User Guide About This DocumentRelated Publications Technical Support Center Introduction AirPoint Nexus Configuration FeaturesSystem Requirements Checklists Pre-Installation Checklist for airPointEconomical One radio model sB3210 Parameters Units Site a Site BSignature of Engineer Name Date Post-Installation Checklist for airPoint RssiChecklist Parameters Units Site a Site B AirPoint Configuration User Login and License AgreementLicense Agreement Web GUI Administrator Password Change Description of Parameters DescriptionsUsing the Configuration Pages Navigation Menu BarEditable Boxes for Parameter Editing Description of Menus Menu Item Menu Sub-itemsWEP Only Menu Item Menu Sub-items DescriptionNone Internal ACLTools Help Ethernet Configurations AirPoint Bridge Configuration ParametersWireless Configuration AirPoint Bridge Wireless Settings Wireless Settings Items DescriptionsItems Descriptions Radio ProtocolRadio Protocol Parameters AirPoint Bridge Performance Settings Configuring Spanning Tree Protocol STP Bridge ConfigurationDefault STP Values Setting Default Value Range Purpose Setting Default Value Range Purpose T e l l i g e n t R e l e s s A t f o r m 11 Bridge Configuration Security WEP only Wireless Equivalent PrivacyWDS Table T e l l i g e n t R e l e s s A t f o r m Internal ACL with WEP disabled External ACLRadius & Internal ACL External ACL Radius & Internal ACL WPA-RadiusWPA radius Traffic Statistics Traffic StatisticsSystem Configuration ToolsSystem Configuration Descriptions Snmp SecurityReset Options Snmp Security ConfigurationNTP Time Server Setup Delayed ResetNTP Time Settings Profile ManagerSave Profile Profile Manager Menu ItemsLoad Operating Profile Profile CalendarLink Test Ping Test ResultLink Budget Planning Throughput Test Result10 Link Budget Planning Calculator Link Budget Firmware Upgrade AirPoint Nexus Firmware UpgradeSuccessful upgrade pop-up window Appendix a Configuration of the Radius Server Produce Certificates T e l l i g e n t R e l e s s A t f o r m Configure Server for TLS Install Windows XP Certificates and Setup Client for TLS Test TLS Change Windows XP for Peap Appendix B Useful terms and definitions Abbreviations AcronymsWPA Snmp Appendix C Snmp Trap Appendix D License