i n t e l l i g e n t | w i r e l e s s | p l a t f o r m |
2.4. airPoint™ Bridge Configuration Parameters
This section explains how to configure the following parameters for airPoint Bridge: Ethernet, Wireless and Bridge Spanning Tree Protocol.
2.4.1. Ethernet Configurations
The Ethernet
Follow the steps below to change the airPoint Bridge Ethernet Configurations:
1.From the ‘Summary Information’ page, click on the ’Ethernet Configuration’ link to change the ’Ethernet Configuration’ parameters.
2.Enter a new ’IP Address’, ’IP Mask’, ’Gateway IP Address’ and ’DHCP’ status (check to enable). If DHCP is enabled, the IP address will be assigned by the DHCP Server.
3.Click on the ’Apply Changes’ button to change the settings.
Figure 2-7 airPoint Bridge Ethernet Configurations
2.4.2. Wireless Configuration
The wireless parameters need to be configured to allow the client devices to associate with the airPoint™ unit.
Follow these steps below to configure the wireless association parameters:
1.Go the menu bar and select ‘Main – airPoint Bridge from the ‘Radio’
2.To configure the wireless settings click on the wireless settings link.
3.Enter the SSID of the airPoint™ unit.
4.Choose a radio domain from the drop down list.
5.Choose the Radio Operating Mode.
airPoint™ Nexus User Configuration Guide | Page 18 of 55 |
|