Silicon Image SSD-C08G(I)-3150 manual Signal Descriptions, Signal Name Pin Type Description

ELECTRICAL SPECIFICATION				SSD-CXXX(I)-3150 DATA SHEET
SIGNAL DESCRIPTIONS
		Table 8: Signal Descriptions
	Signal Name	Pin	Type	Description
	A10-A0	8, 10, 11,	I	These address lines along with the
		12, 14, 15,		-REG signal are used to select the
		16, 17, 18,		following:
		19, 20		• The I/O port address registers
				within the SiliconDrive CF
				• The memory-mapped port address
				registers within the SiliconDrive CF
				• A byte in the card's information
				structure and its configuration
				control and status registers
	A10-A0			This signal is the same as the PC
	(PC Card I/O			Card Memory Mode signal.
	mode)
	A2-A0	18, 19, 20	I	In true IDE mode, only A[2:0] are used
	(True IDE mode)			to select the one of eight registers in
				the Task File. The remaining address
				lines should be grounded by the host.
	BVD1	46	I/O	This signal is asserted high, because
	(PC Card memory			BVD1 is not supported.
	mode)

-STSCHG

(PC Card I/O mode)

This signal is asserted low to alert the host to changes in the RDY/-BSY and Write Protect states while the I/O interface is configured. This signal’s use is controlled by the Card Configuration and Status register.

-PDIAG		In the true IDE mode, this input/output
(True IDE mode)		is the Pass Diagnostic signal in the
		Master/Slave handshake protocol.
BVD2	45	I/O This signal is asserted high, as BVD2
(PC Card memory		is not supported.
mode)

SILICONSYSTEMS PROPRIETARY

This document and the information contained within it is confidential and proprietary to SiliconSystems, Inc.

All unauthorized use and/or reproduction is prohibited.

3150C-10DSR PAGE 6 FEBRUARY 2, 2009