Schumacher IP-95C, IP-125C owner manual Charging the Internal Battery using the Built-In Charger

Page 6

2.7Have plenty of fresh water and soap nearby in case battery acid contacts your skin, clothing or eyes.

2.8Wear complete eye and body protection, including safety goggles and protective clothing. Avoid touching your eyes while working near the battery.

2.9If battery acid contacts your skin or clothing, immediately wash the area with soap and water. If acid enters your eye, immediately flood the eye with cold running water for at least 10 minutes and get medical attention right away.

2.10Stay clear of fan blades, belts, pulleys and other parts that may cause injury.

2.11Clean the battery terminals before using the jump starter. During cleaning, keep airborne corrosion from coming into contact with your eyes, nose and mouth. Use baking soda and water to neutralize the battery acid and help eliminate airborne corrosion. Do not touch your eyes, nose or mouth.

2.12Determine the voltage of the battery by referring to the vehicle owner’s manual and make sure that the output voltage of the jump starter is correct.

2.13Make sure that the Instant Power™ cable clips make tight connections.

3.Control panel

4.Charging the internal battery of the Instant Power™

Important: charge immediately after purchase, after each use and every 30 days to keep the instant power™ INTERNAL BATTERY FULLY CHARGED.

4.1LED Indicators:

To check the internal battery’s charge status, press the Battery Status button on the front of the Instant Power™. The led lights will indicate the charge level as follows:

A red LED indicates a 50% or less charge and you should immediately recharge the Instant Power™.

A yellow LED indicates a 50 to 75% charge. The Instant Power™ may be used but should be recharged as soon as possible.

A green LED indicates the internal battery is fully charged.

The CHARGING (red) LED indicates the Instant Power™ is charging

(connected to an AC power source.) At full charge, the CHARGED (green)

LED will light.

4.2Charging the Internal Battery using the Built-In Charger:

1.To charge, plug an 18 gauge (AWG) or larger extension cord into the charger plug on the left side of the Instant Power™. (Extension cord not included; must be purchased separately.)

3

Image 6
Contents Manual del usuario Page Índice Page Important Safety Instructions Personal PrecautionsRisk of electric shock or fire Charging the Internal Battery using the Built-In Charger Operating Instructions Jump Starting a Vehicle EngineRisk of Explosion Powering a 12V DC Device Using the USB PortAppliance Type Estimated Estimated Usage Storage Using the Air Compressor Risk of explosionEstimated Time for Inflating Charge Immediately After Purchase Keep Fully ChargedTroubleshooting Problem Possible Cause REASON/SOLUTION Replacement PARTS/accessoriesPage Advertencia Instrucciones Importantes DE Seguridad El riesgo de descarga eléctrica o incendioPrecauciones Personales Page Indicador LED Cargando la batería interna con el Cargador Interno AdaptadoRiesgo de Explosión Instrucciones DE OperaciónPara arrancar el motor del vehículo Para hacer funcionar un aparato de 12V de CDEl uso de Puerto USB Tipo de Carga Tiempo AproximadoElectrodoméstico Uso del Compresor de Aire Riesgo de explosiónTiempo estimado para inflar REPUESTOS/accesorios