Velocity Micro SEAL-IT 100 manual Related topics

Page 34

30

Chapter 2: SEAL-IT 100

SEAL-IT 100 Device Driver User Guide

	Setting	Comments

	Roll count	Number of times the rolling operation
		is performed. Always set to 1.

	Roll speed	Speed at which the roller that presses
		the seal onto the plate moves.
		Reduce the speed to get a firmer seal.

	Roll Type:	With Full roll selected, the roller starts
	❑ Full roll	in the middle of the plate, rolls one
	❑ Full roll	half, then returns to roll the other half,
	❑ Half roll	half, then returns to roll the other half,
	❑ Half roll	and then performs a complete roll
		across the plate.
		With Half roll selected, the complete
		roll is omitted.

7. Click OK to save the profile and exit ABgene SEAL-IT 100 Diagnostics.

Related topics

For information about...	See...

Opening diagnostics	“Opening diagnostics” on page 12

Adding the SEAL-IT 100 to the	“Adding devices” on page 10
device manager

The next step	“Setting the properties for a device” on
	page 16

The workflow this procedure	“Workflow for configuring the SEAL-IT
belongs to	100” on page 28

Managing SEAL-IT 100 profiles	“Managing SEAL-IT 100 profiles” on
	page 32

Using SEAL-IT 100 Diagnostics	“Operating the SEAL-IT 100 with
	diagnostics” on page 33

Using SEAL-IT 100 tasks	“Setting SEAL-IT 100 task parameters”
	on page 31

Profiles	“About profiles” on page 15

Image 34

Contents SEAL-IT 100 Device Driver User Guide July VWorks3 and BenchWorksCopyright 2007 Velocity11 Contents Table of Contents Introduction1 Job roles Who should read this guideRelated topics About this topic Where to find user information Online helpAbout Velocity11 user guides To open the online helpPrinting and searching More information Driver version What this guide coversAlso read What this guide does not coverDevice defined About devicesDevice file defined About device drivers IWorks interface What functions do the device drivers provide? Related topicsProcedure Installing device driversTo install device drivers To add devices to a device file Adding devicesClick the Device Manager tab Background About diagnosticsSelect File Device File Save Opening diagnostics To open DiagnosticsIf you are using VWork3 or BenchWorks software Related topics About profiles Stored settingsProfiles defined Before you start Setting general properties Setting the properties for a deviceTo set the general properties for a device Open the Device Properties Setting teachpointsSetting location properties Teachpoint for robot robot’s name. Choose a fileSetting the Use linked location Sub Process task defined Adding a Sub Adding and linking Sub Process tasksTo link the Sub Process task to the correct sub-process To link a Sub Process task to a device Pipette Process Editor, select the Sub Process link iconUsing JavaScript to set task parameters Where scripts are writtenAbout reader output files Plug-in defaultOutput file Profile default output file name Filename suffixes ExampleOverriding output file names with tasks Homing motors Setting profile parameters About device initializationIntroduction SEAL-IT Workflow for configuring the SEAL-IT WorkflowBefore you start Open ABgene SEAL-IT 100 DiagnosticsCreating a SEAL-IT 100 profile To create a SEAL-IT 100 profileRelated topics Setting Seal Plate SEAL-IT 100 task parameters Setting SEAL-IT 100 task parametersTo set the Seal Plate ABgene SEAL-IT 100 task parameters Managing SEAL-IT 100 profiles Managing profiles To manage SEAL-IT 100 profilesBefore you start Sealing and trimming a plate Operating the SEAL-IT 100 with diagnosticsOpen SEAL-IT 100 Diagnostics To initialize the SEAL-ITProfiles tab