UBC93XLT Paper OM.fm Page 31 Monday, May 14, 2007 9:01 AM
2 seconds after the end of a transmission before scanning proceeds to the next channel. To turn the function off or on, press Func + Dly.
•If you enter a frequency that has already been entered elsewhere, the scanner sounds an error tone and displays the channel that was duplicated. If you entered the frequency by mis- take, press 
then enter the correct frequency. To enter the frequency anyway, press E to accept.
4.To program the next channel in sequence, press E/Pgm then repeat Steps 2 and 3.
Searching For and Temporarily Storing Active Frequencies
If you do not have a reference to frequencies in your area, use a search to find a transmission.
There are two search features available. Service Search (see below) and Chain Search on page 38.
Note: When the scanner starts searching, it auto- matically turns on the delay function. To turn delay on or off, press Func + Dly.
Service Search
You can search for police, railroad, marine, aircraft, UHF CB, and AM CB transmissions without knowing the specific frequencies used in your area. The scanner is preprogrammed with all the frequencies allocated to these services. To use this feature, press Func + Svc. SRCH appears and the scanner searches starting with the police service bank. To select a different service bank, repeatedly press Func + Svc. Service mode appears on the display.
When the scanner stops on a transmission, press Hold to stop searching and listen to the transmission. Hold appears. In this mode, you can
Operation
31