UB343ZH_UBC785XLT_OM_0622 6/22/06 3:01 PM Page 32
Priority Scan
When Priority Scan is turned ON, your scanner checks the priority channel in the banks you selected every 2 seconds for activity. If a signal is present on the priority channel, your scanner monitors the channel until the transmission ends, then resumes normal scanning. You can designate one channel in each bank as a Priority Channel. By default, the first channel in each bank is the Priority Channel, but you can change this.
To activate Priority Scan (in either the Hold or Scan Mode):
1. Press PRI to select PRIORITY ON.
Note: If you have locked out the priority channel, ERROR appears when you select Priority mode.
2.Press PRI to select PRIORITY OFF to deactivate Priority Scan.
PRIORITY ON
C 010
1240.0000 FM
ERROR
PRI CH LOCKOUT
Changing the Priority Channel
You cannot eliminate the Priority Channel, but you can change it to any one of the 100 available channels in each bank.
1.Press ▲/HOLD.
2.Select a new Priority Channel using the keypad, then press ▲/HOLD again.
3.Press and hold PRI for 2 seconds to designate this channel as your new Priority Channel.
Two beeps indicates that the Priority Channel has been changed. The P icon appears on the display.
C 005
512.0000 FM
UHF TV 1 UNIDEN Group A
Priority Channel Plus Scan
You can scan only the Priority Channels (except for the locked out channels) in the banks you selected.
To activate Priority Channel Plus (Only in Scan mode):
Press PRI to select PRIORITY PLUS.
To deactivate Priority Channel Plus:
Press PRI to select PRIORITY ON or PRIORITY OFF on the display to deactivate Priority Channel Plus Scan.
Note: Priority or Priority Plus Scan are disabled while Search mode is selected.
32