UB343ZH_UBC785XLT_OM_0622 6/22/06 3:01 PM Page 36
Auto Storing
The scanner automatically stores active frequencies if its Auto Store feature is turned ON. But the frequencies already stored can not be stored. To make use of this feature, set a search range first (see page 33). If you start this feature without setting a search range, NO LIMIT DATA appears on the display.
1.Press MENU.
2.Select 1:SERVICE OPTION / 2:CHAIN SEARCH / 7:AUTO STORE by rotating the VFO and pressing E.
3.Select 1:ON by rotating the VFO and pressing E.
☞ Remember! You can also use ▲ or ▼ instead of rotating the | AUTO STORE |
VFO. Also instead of pressing E, you can press the VFO | SELECT BANK |
control. |
|
4. Select the bank number you want to store with the keypad. |
|
The selected bank number appears on the display. |
|
| |
Note: If the selected bank has no free channels to store, CH | AUTO STORE |
DATA FULL will appear on the display and you will | ERROR |
hear a beep. | CH DATA FULL |
| |
6. Press SRCH to start auto storing. |
|
7.When the selected bank has no free channel, the scanner stop auto storing and STORE END appears. If you want to stop auto storing on the way, press ▲/HOLD.
Squelch (SQ) Mode
The scanner has the following SQ modes.
C 001
1245.8500 FM Bank 12--56----
AUTO STORE
•Carrier SQ mode (default setting)
The scanner will stop on any active frequencies or squelch opening, regardless of whether any subaudible tone has been programmed on your scanner for the channel or search range.
•Tone SQ mode
The scanner will stop on any active frequency for which you have not programmed any subaudible tone or whose subaudible tone is the same as the one you have programmed.
•Tone Search mode
When the scanner stops on an active frequency, the scanner will begin searching the sub- audible tone used on the frequency one of which may also be in use. The scanner counts up through the CTCSS tones and instantly determines any possible DCS tone. See Page 51 for a listing of the tones that the UBC785XLT decodes.
Note: When Tone Search is active and the scanner finds the subaudible tone used on a frequency, CTCSS or DCS and subaudible tone flashes. You can press E to pro- gram that frequency with the found subaudible tone. When you change the mode to Tone SQ from Tone Search, you can confirm the frequency and subaudible tone has been programmed.
36