Uniden UBC144XLT manual IPressG, Except those channels programmed with ~

Page 12

=

Scanning

SCAN

Turn on the power, or press C. SCAN)to start scanning. (When the scanner is turned on, it is automatically in Scan mode.)

Scanning stops on any active channel automatically,

except those channels programmed with ~

.

Scanning resumes automatically 2 seconds after the channel becomes inactive.

Press C.MANUAL)any time to stop scanning. When you press

~, you are out of Scan mode, and the scanner remains on the displayed channel.

Pres~ c:scAN)to start scanning again, or press ~	to
step up 1 channel.

You can press ~ repeatedly to manually scan all 16

channels, 1 press per channel, including the channels that are locked out.

Direct Chan nel Access

This feature allows you to instantly access a specific channel you want to monitor.

Example: Select Channel 4.

G) (i) IPressG).

CDCD

om

Press C. MANUAIJ .

SCAN

When you press~, the display changes to "4", but the scanner still monitors the

previous channel displayed. You must press C. MANUAL)to successfully complete the direct access to Channel 4.

10

Image 12

Contents UBC144XLT Channel Base ScannerPreca UTI 0 NS Uniden- is a registered trademark of Uniden CorporationTable of Contents Introduction TypesofTakingProperCareof YourScanner UnpackingInstallation Installingthe UBC144XLT Also, use for direct channel access with ~ Regardless of any other mode the scanner is in. If aChannel! until no signal is present. Priority mode is Cancelled when you turn off the scannerChannel Display WXKey0iX REVIEWKeyScanning Overview Getting StartedAdjusting the Squelch Current channel numberCorrect frequency is stored in the scanner By programming a new frequency over the existing oneProgramming Frequencies Thenpress~ AgainIPressG Except those channels programmed with ~You can press ~ repeatedly to manually scan all Checking the Programmed Frequency If youentera frequencythatis notan exactstepwithintherangePressREViEWto check the frequency programmed Press GViX to find the active weather channel in yourPress ~RIORITY to set the scanner in Priority Scan mode Priority ScanningChan nel Lockout Channel1LockedOutscanning Channel Allradiosaresubjectto receivingundesiredsignalsor About the UnitThereceiver.PressGSCANto resume scanning Problem Troubleshooti ngTechnical .specifications SecondsServIce Princes Highway, Rockdale, NSW Ph 02 599 3100 FAX 02 599@1994Uniden Austrnlia Pty. Limited All rights reserved