Uniden manual Installation Installingthe UBC144XLT

Page 6

Installation

Installingthe UBC144XLT

AC 1aV Jack

Antenna Jack

AC Plug/

Telescopic Antenna

AC Adaptor

Model AC-144U

1.Insert the DC plug end of the AC Adaptor into the AC 10 V jack on the scanner.

2.Plug the AC Adaptor into any standard 240 VAC wall outlet.

3.Plug the Telescopic Antenna into the ANT~jack. Extend the antenna to its full height. For UHF frequencies, shortening the antenna may improve the reception.

4.Plug an optional external speaker C8-ohm)into the EXT.SP.jack.

Notes

If strong interference or electrical noise is received, relocate the scanner or its antenna away from the source.

If you are operating the scanner in the fringe area or need to improve reception, use an optional antenna designed for multi-band coverage. (You can purchase this type of antenna at a local electronics store.) If the optional---antenna has no cable, use 50-70 ohm coaxial cable for lead-in. A mating plug may be necessary for the optional antennas:

---

----

Image 6

Contents UBC144XLT Channel Base ScannerPreca UTI 0 NS Uniden- is a registered trademark of Uniden CorporationTable of Contents Introduction TypesofTakingProperCareof YourScanner UnpackingInstallation Installingthe UBC144XLT Channel! until no signal is present. Priority mode is Also, use for direct channel access with ~Regardless of any other mode the scanner is in. If a Cancelled when you turn off the scanner0iX Channel DisplayWXKey REVIEWKeyScanning Overview Getting StartedCorrect frequency is stored in the scanner Adjusting the SquelchCurrent channel number By programming a new frequency over the existing oneProgramming Frequencies Thenpress~ AgainIPressG Except those channels programmed with ~You can press ~ repeatedly to manually scan all PressREViEWto check the frequency programmed Checking the Programmed FrequencyIf youentera frequencythatis notan exactstepwithintherange Press GViX to find the active weather channel in yourChan nel Lockout Press ~RIORITY to set the scanner in Priority Scan modePriority Scanning Channel1LockedOutscanning Channel Allradiosaresubjectto receivingundesiredsignalsor About the UnitThereceiver.PressGSCANto resume scanning Problem Troubleshooti ngTechnical .specifications SecondsServIce Princes Highway, Rockdale, NSW Ph 02 599 3100 FAX 02 599@1994Uniden Austrnlia Pty. Limited All rights reserved