Uniden UBC144XLT manual Technical .specifications, Seconds

Page 18

Technical .specifications

Band Coverage: F'rfttuencyCoverage:

Sensitivity (nominal) 121dB SINAD:

Selectivity (nominal):

Channels :

Scan ,Rate:

Scan Delay:

Audio Output (nominal):

Power Requirements:

Antenna:

External Jacks:

Size:

Weight:

8 bands

66.0-88.0MHz VHFLowBand

137-144MHz LandMobile

144-148MHz 2 MeterAmateurBand

148-174MHz VHFHighBand

Above bands in 5 kHz steps

406-420 MHz

Land Mobile

420-450 MHz

70cm Amateur Band

450-470 MHz

UHF Standard Band

470-512 MHz

Land Mobile

Above bands in 12.5 kHz steps

0.5f.1V 66-88 MHz

0.4f.1V137-174 MHz

0.6f.1V406-512 MHz

-6 dB at 180kHz<J62.4MHz 20 dB QS) -50 dB at 30 kHz (162.4 MHz 20 dB QS)

16

Up to 15 channels per second

2seconds

0.9W (max.) 10%THD

10 VAC using AC-l44U AC Adaptor

Telescopic (included)

Antenna jack

External speaker

AC 10V power jack

245 mm (W) x 200 mm (D) x 59.5 mm (H)

585g

Features, specifications, and availability of optional accessories are all subject to

change without notice.

16

Image 18
Contents UBC144XLT Channel Base ScannerPreca UTI 0 NS Uniden- is a registered trademark of Uniden CorporationTable of Contents Introduction TypesofTakingProperCareof YourScanner UnpackingInstallation Installingthe UBC144XLT Channel! until no signal is present. Priority mode is Also, use for direct channel access with ~Regardless of any other mode the scanner is in. If a Cancelled when you turn off the scanner0iX Channel DisplayWXKey REVIEWKeyScanning Overview Getting StartedCorrect frequency is stored in the scanner Adjusting the SquelchCurrent channel number By programming a new frequency over the existing oneProgramming Frequencies Thenpress~ AgainIPressG Except those channels programmed with ~You can press ~ repeatedly to manually scan all PressREViEWto check the frequency programmed Checking the Programmed FrequencyIf youentera frequencythatis notan exactstepwithintherange Press GViX to find the active weather channel in yourChan nel Lockout Press ~RIORITY to set the scanner in Priority Scan modePriority Scanning Channel1LockedOutscanning Channel Allradiosaresubjectto receivingundesiredsignalsor About the UnitThereceiver.PressGSCANto resume scanning Problem Troubleshooti ngTechnical .specifications SecondsServIce Princes Highway, Rockdale, NSW Ph 02 599 3100 FAX 02 599@1994Uniden Austrnlia Pty. Limited All rights reserved