Uniden UBC144XLT manual Table of Contents

Page 3

Table of Contents

I

Introduction
AboutScanning	2
TakingProperCareofYourScanner	3
Unpacking	3
Installation
InstallingtheUBC144XLT	4
Operation
ControlsandFunctions	5
ScanningOverview	7
Getting Started	7
AdjustingtheSquelch	8
Programming Tips	8
Programming Frequencies	9
AboutMemoryBack-up	9
Scanning	10
Direct Channel Access	10
CheckingtheProgrammedFrequency	11
WeatherChannelScan	11
Priority Scanning	12
ChannelLockout	12
About the Unit
HelpfulHints	14
Troubleshooting	15
TechnicalSpecifications	16
Warranty

1

Image 3

Contents Channel Base Scanner UBC144XLTUniden- is a registered trademark of Uniden Corporation Preca UTI 0 NSTable of Contents Typesof IntroductionUnpacking TakingProperCareof YourScannerInstallation Installingthe UBC144XLT Cancelled when you turn off the scanner Also, use for direct channel access with ~Regardless of any other mode the scanner is in. If a Channel! until no signal is present. Priority mode isREVIEWKey Channel DisplayWXKey 0iXGetting Started Scanning OverviewBy programming a new frequency over the existing one Adjusting the SquelchCurrent channel number Correct frequency is stored in the scannerThenpress~ Again Programming FrequenciesIPressG Except those channels programmed with ~You can press ~ repeatedly to manually scan all Press GViX to find the active weather channel in your Checking the Programmed FrequencyIf youentera frequencythatis notan exactstepwithintherange PressREViEWto check the frequency programmedChannel1 Press ~RIORITY to set the scanner in Priority Scan modePriority Scanning Chan nel LockoutLockedOutscanning Channel Allradiosaresubjectto receivingundesiredsignalsor About the UnitThereceiver.PressGSCANto resume scanning Troubleshooti ng ProblemSeconds Technical .specificationsPrinces Highway, Rockdale, NSW Ph 02 599 3100 FAX 02 599 ServIce@1994Uniden Austrnlia Pty. Limited All rights reserved