Uniden BC 235XLT specifications Search Hold Feature

Page 26

5.To turn off a Chain Search band during search scanning, press its location number.

For example, (a) if Chain Search locations 1, 2 and 3

are selected, (b) press 3 to turn off band three so that it’s not scanned during your search.

Search Hold Feature

1.Press U or D at anytime to stop the search.

2.Press U to move to the next higher frequency

—OR—

(See Step 3)

3.Press D to move down to the previous frequency.

4.Press R to resume searching.

Note: The search continues toward either the upper or lower search limit,

depending on which direction key (U or D) was pressed last.

26

Image 26

Contents Table of Contents Introduction What is Scanning?What is Searching? Types of Communications FrequencyTransmission RangeFeature Highlights Where to Obtain More Information Included with Your Scanner Setup Installing the BatteriesAC Adapter/Charger Charging WarningBelt Clip Adapter Safety FeatureFlexible Antenna Setting the Squelch Basic OperationStrong Signals Medium Signals Weak Signals Keylock Programming Duplicate Frequency Alert Programming Tips Scanning Lockout in Manual Mode Channel LockoutLocking a Channel While Scanning Lockout TipsRestore a Locked Out Channel Restore All Locked-out Channels Priority Scan Changing the Priority Channel Setting a Search Range Chain SearchPage Page Search Hold Feature Channel Skip Storing Search FrequenciesChain Page Weather Scan General Use Care and MaintenanceCleaning LocationRepairs BirdiesTroubleshooting Problem SuggestionSpecifications Frequency RangeAccessories and Replacement Parts One Year Limited Warranty Uniden America Corporation. All rights reserved