VIPowER VP-9258(T) user manual Finally, secure the upper case with the two retaining screws

Page 11

12. Finally, secure the upper case with the two retaining screws.

4-3 Connect the USB 2.0 External Enclosure VP-9258(T) to Your Computer

Step1:

Boot-up your computer. Make sure the USB/USB 2.0 host adapter and driver are installed in your computer.

Step2:

Connect one USB connector end of the USB cable into the USB Port of your USB 2.0 External Enclosure VP-9258(T).

Step3:

Connect the Power Adapter Power Cord to the +5V/+12V Power Adapter. Then, plug one end of power cord into an AC power outlet, and the other end to the power inlet of your USB 2.0 Ex- ternal Enclosure VP-9258(T).

Step4:

Power ON your USB 2.0 External Enclosure VP-9258(T).

Step5:

Proceed to the next “Driver Installation” section and follow the instructions for your operating system after plugging the USB connector end of the USB cable into a USB port on your computer.

Note:

This device will auto-detect the speed of your USB port and adjust between USB 1.0 and USB 2.0 speed once the driver is installed.

VP-9258(T) USER MANUAL

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents VP-9258T Proprietary Notice Contents Introduction Features and SpecificationsSpecifications USB 2.0 External Drive Only one jumper can be set at the same time Temperature Control Jumper Settings Only VP-9258TPackage Checklist JP8 2-pin Jumper Power LED indicatorSystem Requirements Hardware Operating System Hardware InstallationAssembly Page Page Finally, secure the upper case with the two retaining screws Windows 98SE Drivers InstallationPage Page Page Windows Me/2000/XP Connect the USB 2.0 External Enclosure VP-9258T to Computer Using The USB 2.0 External EnclosureMac OS 9.X or Above Page MAC OS Partition Under Windows 98/ME Partitioning the External USB 2.0 Hard DiskNext screen is Fdisk OPTIONS. Type 5 to select the disk Partition under Windows 2000/XP
Top Page Image Contents