VIPowER VP-8058L installation manual Introduction, USBdock Features

Page 3

1-1 Introduction

Congratulations on your purchase of the USBdock docking kit. The USBdock is an external USB interface adapter which is designed to enable hot-swap, plug-and-play operationofEnhancedIDEorATA/ATAPIdevicesthroughtheUSBinterfaceonany USB-equipped computer. The USBdock’s 50-pin Centronics connector is designed for use with external devices using the same connector type (such as CD-ROM) and the Mobile Rack drive case, which provides the perfect solution for data backup and transporting of data between computers using hard disk drives, zip drives, LS-120 drives, MO drives, tape drives, digital film readers and more.

The USBdock connects to any notebook,iMac, Net-PC, Micro ATX PC, LCD panel PC, Mac and PC desktop computer equipped with a USB port. The USBdock allows you to easily hot-swap various types of drives mounted in the Mobile Rack without interrupting the computer’s current operation.

This manual will guide you through the hardware installation of the following USBdock models:

Model VP-8058USBdock Docking Kit with Mobile Rack (VP-10LSF) Model VP-8058LUSBdock Docking Kit (without Mobile Rack)

1-1.1 USBdock Features

Enables hot-swap Plug-and-Play operation of ATA (IDE) and ATAPI devices with computers using the USB interface

Complies with USB specification V1.1 and USB Mass Storage Specification V1.0 High Speed USB 12Mbits/sec Bulk mode transfer which yields overall 1.1 MBytes/sec burst transfer rate

High performance embedded processor to reduce firmware overhead dual (ping-pong) buffer to minimize bus latency

Intelligent interface uses no host CPU resources to control/monitor time-consuming drive phases other than data transfer

Embedded MacOS and Windows 2000 drivers support Plug-and-Play without additional driver installation

Proprietary Windows driver supports most devices

Universal firmware supports all devices, automatic detection for ATA or ATAPI protocol

Available in various board form factors for specific applications

Perfect for adding/sharing external storage devices between computers using the USB interface

Actual data rate may vary depending on bus utilization and device response time

USBdock Installation Manual

1

Image 3
Contents Installation Manual Table of Contents Introduction USBdock FeaturesDrive Type +5V +5V/+12V Power Requirements2 ATA/ATAPI Device Compatibility Unpacking Your USBdockMobile Rack Stand Set Installed InstallationInstall Driver Software For Windows 98 only Install Stand Set on Mobile RackSetting Up the USBdock for Operation USBdock Power Select Switch & Connector LocationsUSBdock Power Select Switch Settings Using the +5V/+12V AC/DC Power Adapter Device is now ready to useUSBdock Connections for Operation Accessories Disconnecting the USBdock