VIPowER VP-8058L Setting Up the USBdock for Operation, USBdock Power Select Switch Settings

2-1.3 Setting Up the USBdock for Operation

LED Indicators

Power	Drive Activity
+5V
External	50-Pin Centronics
Power	Device Connector
Connector
Power Select
Switch
+5V +12V
External	USB
Power Connector	Connector

USBdock Power Select Switch & Connector Locations

Perform the following steps (in the order given) to set up the USBdock with your peripheral device for operation:

1.For Windows 98 users: verify that the Windows 98 driver is installed.

2.Plug the USBdock’s 50-pin Centronics connector into the connector on the device you plan to connect to your computer.

a.External devices that provide a 50-pin Centronics interface connector support direct connection with the USBdock.

b.Internal devices such as EIDE hard drives or ATA/ATAPI devices can be mounted in the Mobile Rack drive case. (Refer to the Mobile Rack manual for instructions on mounting these devices in a Mobile Rack.)

IMPORTANT

Make sure the Power Select switch on the USBdock is set to the MIDDLE power OFF position before proceeding.

External Power Adapter

Power OFF

+5V USB Interface

USBdock Power Select Switch Settings

4 USBdock Installation Manual