EVGA 750i SLI manual ECC Control, System Voltages, CPU Core, Memory

EVGA

wCommand Per Clock: This is the command timing setting on a per clock unit basis (options are 1T and 2T).

wtRRD: RAS#-to-RAS# delay of different banks (options are 1 through 15).

wtRC: RAS#-to-RAS# or auto refresh time of the same bank (options are 1 through 31).

wtWR: The Write recovery time (options are 2 through 7).

wtWTR: This is the minimum write-to-read delay with the same chip selected (options are 1 through 10).

wtREF: This is the DRAM refresh rate (options are Auto, 7.8uS, and 3.9uS).

ECC Control

Disabled

System Voltages

Select System Voltages from the Frequency/Voltage Control menu and press Enter to display the System Voltages menu.

Phoenix – AwardBIOS CMOS Setup Utility

System Voltages

Parameters	Settings	Current Value
CPU Core	[Auto]	1.28
CPU FSB	[Auto]	1.20V
Memory	[Auto]	1.900V
nForce SPP	[Auto]	1.30V
NF200 Voltage Level	[Auto]	1.20V
GTLVREF Lane 0	[Auto]	+00mv
GTLVREF Lane 1	[Auto]	+00mv
GTLVREF Lane 2	[Auto]	+00mv
GTLVREF Lane 3	[Auto]	+00mv

Users should exercise caution when over-voltaging, ,as it can cause system instability or even void warranties and damage components.

Item Help

Main Level

Voltage level for CPU Core (CPU VID)

:Move Enter:Select +/-/PU/PD:Value	F10:Save ESC:Exit F1:General Help
F5: Previous Values	F7:Defaults

CPU Core

Use the Page Up and Page Down keys to scroll through the voltages or select [Auto] to automatically set the voltage level for the CPU Core.

CPU FSB

Use the Page Up and Page Down keys to scroll through the voltages or select [Auto] to automatically set the voltage level for the CPU FSB.

Memory

This function defines the voltage level for the DRAM. Use the Page Up and Page Down keys to select a voltage or select [Auto] to automatically set the voltage.