OPERATION TESTS AFTER INSTALLATION
1.Test of
Note: H.323 Handler
a.) | See if the |
|
|
|
| This lamp will light if the circuit card is physically connected to the IP |
|
|
|
|
|
|
| |
| network. | ATTENTION | ||
|
| Contents | ||
Note: H.323 Handler | Static Sensitive | |||
Handling | ||||
|
| Precautions Required | ||
b.) | When the |
|
|
|
| connected to the IPCON connector. Make sure that neither the Ethernet cable nor the router are | |||
| faulty. If necessary, replace the Ethernet cable. |
|
|
|
2.Test of SUBOPE1 lamp on IPTRK circuit card Note:
Note: H.323 Handler
a.) See if the SUBOPE1 lamp on the IPTRK circuit card Note is lighting green. This lamp will light when the appropriate data has been assigned on the Gate Keeper (GK) side.
Note: H.323 Handler
b.) When the SUBOPE1 lamp is OFF, make sure that the related office data is correctly assigned on both the PBX side and the Gate Keeper (GK) side.
3.Test of
Note: H.323 Handler
a.) See if the
Note: H.323 Handler
b.) When the
4.Test of Speech Conditions with Distant Node:
a.) Perform the connection test to see if speech can be made with the counterparts of the connected node.
b.) If any test result is abnormal, make sure that the related office data was assigned correctly.
5.Test of System Messages:
a.) When an IPTRK circuit card Note is installed, the following messages may be created:
Note: H.323 Handler
•For CCIS Networking via IP
b.) When any of the messages above are created, make sure that the Ethernet cable is securely connected to the IPCON connector (on the IPTRK circuit card), or perform the continuity test of the cable (voltage and resistance measurement), using a voltmeter. Otherwise, replace the IPTRK circuit card or H.323 Handler.
CHAPTER 4 |
Page 48
Issue 1