OPERATION TESTS AFTER INSTALLATION
3.FCCS NETWORKING VIA IP [F-36]
When using the IPTRK circuit card for FCCS Networking via IP
ATTENTION
Contents Static Sensitive
Caution:Some LSIs on this circuit card may be hot. Handle with care.
1.Test of OPE lamp on IPTRK circuit card:
Handling Precautions Required
a.) See if the OPE lamp on the IPTRK circuit card is lighting green. This lamp will light if the circuit card is operating normally.
b.) When the OPE lamp is OFF, initialize the circuit card, or perform the insertion/extraction of the circuit card once or twice. If the lamp still does not light, replace the circuit card.
2.Test of SUBOPE0 and SUBOPE1 lamps on IPTRK circuit card:
a.) See if the SUBOPE0 and SUBOPE1 lamps on the IPTRK circuit card are lighting green. Note that SUBOPE1 should light if the circuit card is furnished with an optional sub board (PZ- 8VCTB).
b.) When either (or both) of the lamps are OFF, initialize the circuit card, or perform the insertion/ extraction of the circuit card once or twice. Also, if a sub board is in use, make sure the daughter board is securely attached to the IPTRK circuit card (main board). If the lamp still does not light, replace the circuit card.
IP-LRR
Is IP network available for connection?
Is
Is FCCS network available for connection?
F-LINK
Is
Not Used
MB
MBR
BUSY SUBOPE3 SUBOPE2
L3
L2
L1
Not Used
MODE
IPCON
FCON
OPE
Is IPTRK card operating normally?
SUBOPE1
Is CPU of sub board operating normally?
SUBOPE0
Is CPU of IPTRK card’s main board operating normally?
L1
Is FCCS network link established?
Sub Board
IPTRK Circuit Card
Figure 4-2 Lamps to be Tested (FCCS Networking via IP [F-36] [Point-to-Multipoint Connection])
Page 49
Issue 1