3Com 86-0621-000 Remote Access, Scheduler, RunOnBootFail, Completion, 25bis Modem Setup, Web Link

60

	table and re-enable BootP on the port waiting for the IP address. BootP must be
	re-enabled before route update are received.
Remote Access	To increase network security, the default value for the NetAccess parameter in the
Default Change	SYS Service is set to NoRemote. This means that by default, no remote connection
	attempts will be accepted by the bridge/router. If you are accustomed to or want
	to use remote access, you must specifically set the value of the NetAccess
	parameter to Remote.
Scheduler	When RunOnBootFail is specified, event-based macro execution (EBME) is enabled
RunOnBootFail	when the primary connections fail to establish within 5 minutes after the switch
Completion	boots. After the initial 5 minutes, PortDown event processing happens at the rate
	of approximately one port per second. When the PathBuilder S5xx series switch is
	configured for 2048 virtual ports it takes about 45 minutes after the system
	initializes for the RunOnBootFail processing to be completed on all ports.
V.25bis Modem Setup	If you are using a V.25bis modem with a NETBuilder boundary routing leaf node,
	and you configure the line type explicitly as dial rather than auto, be certain to also
	set the DialMode to V.25bis rather than use the default of DTR.
Web Link	When you set the DocumentPath parameter in the WebLink service to a local file,
Documentation Path	drive C for example (“file:///c:”), the Web Link assumes that access to the
	NETBuilder bridge/router takes place only from the computer to which the file is
	local. If Web Link is used from any other computer, the browser looks on its local
	“C” drive for the help pages. If the computer is a UNIX machine and these files are
	not present as expected, unpredictable browser behavior will result.
Web Link Login Support	When you access the Web Link application for the first time, you are prompted to
	enter a username and password. This username and password remains valid on
	the NETBuilder bridge/router for two hours. Because most browsers cache user
	login information, it is recommended that you log out of Web Link by selecting
	the “Logout” icon on the home page.
Zmodem Time Out	A Zmodem file transfer from a PC to a SuperStack II or OfficeConnect
	bridge/router can take a long time. To minimize the possibility that the PC
	Zmodem software will time out during the download, run the DEFRag command
	on the SuperStack II bridge/router before beginning the file transfer. The DEFRag
	command reclaims dirty space in flash memory. Dirty space is memory that has
	been written on and cannot be used again until it has been erased.
VPN Protocols and	This section describes notes, cautions, and other considerations to be aware of
Services Notes	when using the Enterprise OS software with VPN protocols and services. The
	topics are presented in alphabetical order.
ACE Security Server	When interoperating with the ACE Security Server for Token-based login support,
	you may need to change the RAS Retransmit Timer value to a higher value (for
	example, 7) to prevent access-request time-outs.
Total Control Security	The Total Control™ Security and Accounting Server provides call authentication,
and Accounting Server	authorization, and accounting for your Enterprise OS devices. At the time of
Availability	publication of these release notes, the required version number of the SAS server