Panasonic AW-PB309P Image display method, http//new IP address setting/user/pb309.html, Quality

Page 9
Image display method
Image Control

Image display method

Start up the browser, and input the address.

http://(new IP address setting)/user/pb309.html

Images can be displayed when the following address is input in the factory setting status.

http://192.168.1.50/user/pb309.html

When this address is input, an image such as the one shown in Fig. 1 appears. (The image is a sample.)

HIGH is set for the image quality and VGA (640

a480) is set for the size in the initial status.

To change the image quality or size, click the button under the image.

When this button is clicked, the window shown in Fig. 2 is opened. Now change the setting or settings.

QUALITY and SIZE on the Image Control window function as follows.

1) QUALITY

HIGH : JPEG compression rate of approximately one-sixth

MID : JPEG compression rate of approximately one-ninth

LOW : JPEG compression rate of approximately one-fifteenth

These compression rates differ from one subject to another and thus serve merely as guidelines.

2)SIZE

VGA : JPEG compression using 640 a 480 pixels

HVGA : JPEG compression using 640 a 240 pixels

QVGA : JPEG compression using 320 a 240 pixels

Fig. 1

Fig. 2

In the HVGA mode, JPEG compression is implemented in 1-field increments, and images are enlarged to twice their original size in the vertical direction and displayed by the browser. This mode is best suited to subjects which move a lot.

The quality and size in which the image is to appear when the power is turned on can be set on the Config screen. (See pages 12 and 13)

<Note>

If the “Image Display” and “Image Control” windows are open and these windows are to be exited, close each window.

(The “Image Control” window will not be automatically exited when the “Image Display” is closed.)

9

Image 9
Contents AW-P WEB cardRDY RST LINK/RX FCC Note indicates safety informationContents Precautions for useIntroduction Parts and their functions Before use3 Turning the WEB card’s power ON and OFF 1 The image updating interval is not a fixed oneInstallation Ask your dealer to install the card in the camera 3 Installation and settings at the PC end System upgrading1 Connections 2 Recommended system requirements4 Setting the WEB card’s IP address IP address Net maskIP address Net mask Gateway http//192.168.1.50/config/config.html 5 Re-setting the PC’s addresshttp//new IP address setting/config/config.html Reference Resetting methodhttp//new IP address setting/user/pb309.html Image display methodhttp//192.168.1.50/user/pb309.html 1 QUALITYhttp//new IP address setting/config/config.html Config screen3Password 2Default Image setting1Network 4Submit QueryTypes of passwords PasswordsConcerning the characters used to set the passwords http//192.168.1.50/config/config.html1 Monitor password Types of passwords2 Operation password 3 Management passwordPasswords External dimensions drawing Pan/tilt head and camera controlServer functions ¢1 How to use the ping command Before requesting servicee.g. Reply from 192.1.50 bytes=32 time10ms TTL=255 Request timed outSpecifications and accessories SpecificationsAccessories Page