Panasonic DP-2500 manual Automatic Duplex Unit ADU, Close the Right Cover

Page 62

Problem Solving

4

Automatic Duplex Unit (ADU)

#Open the Paper Feed Guide. $Remove the misfed paper.

5

Close the Right Cover.

 

ATTENTION CMake sure that the Misfeed Indicator goes off after removing all misfed paper.

62

Image 62
Contents DP-2500/3000 EnglishOperation Chart Common Features and UsageTouch Panel Display Function CategoriesEnergy Star Table of Contents Others Problem SolvingOptions Laser Safety PrecautionsFor Your Safety Handling Toner and Paper VentilationInstallation FCC Warning For U.S.AControl Panel Starting DisplayContents Refer to Touch Panel Display IndicationsBasic Menu Full Size CopyingSelect the Copy Copying with Preset RatiosReduction or Enlargement Copying Copying on Special Paper, etc Using the Sheet Bypass$Adjust the side guides # Place approximately 50 sheets of paper into the traySided/Original H Copy Sided/Orig. H Copy KeyTouch 1 \ Procedure\ 2/2 \ 1/2 \ 2 Copy Place the Original Select Book \ On the Platen Mode and CopyBook \ 2 Copy FormatOriginals CopyPlace Touch ModeMake Selection Touch N in 1 Mode1 Copy 1 CopyMode Booklet CopyTouch Booklet Booklet CopyPlace the Original Select One at a Time Function Sadf ModeSadf Single Sheet Automatic Document Feeder Function Csadf function cannot be combined with 2 \ 1 and 2 \Zoom/Effects Zoom/Effects KeySelect Zoom Zoom CopyingZoom Numbering FeatureNumbering Margin or Book Margin/Book/EdgeSelect Edge Insertion/Overlay Insertion/Overlay KeyOHP Interleaving Interleaving ModeOHP Interleaving Blank Paper Copied PaperOverlay Overlay ModeOverlay 1st-pageOverlay To recall a job stored in memory Job MemoryTo store a job in memory Sleep Mode Other FeaturesEnergy Saver Mode Interrupt Mode# Touch the Copier Settings key Manual Skyshot Mode/Digital Skyshot ModeSetting the Digital Skyshot Mode Touch the 06 Digital Skyshot key# Select the Copier Settings in Function Setting mode Setting the Manual Skyshot ModeChanging the default M1/M2 size See Touch the 09 KEY Operator Mode keyCombined Function Table Function Using Function Modes to Change the Initial Copy ModesFunction Key Reset Key OptionsModes Function Initial Setting General FunctionsCopier Settings Screen Modes Function Initial SettingInput the Key Operator ID Code to Change Settings General Functions for Key OperatorORIG. SET Beep Copier Settings for Key Operator 10 MAX. Copy Setting #Touch Copier Settings Function SettingChanging the Auto Exposure Setting Proceed as FollowsChanging the Paper Size Function Setting for Key OperatorSelect 09 KEY Operator Mode key #Touch General FunctionsPaper Guide a Stopper Guide b # Select General Functions KEY Operator Mode keyDepartmental Counter Maximum Number of Copies Exit function modeChange the Department Counter Number, ID Code and limit Accessories ComponentsADF DA-AS200/i-ADF DA-AR250 FeaturesAutomatic Document Feeder ComponentsOriginal OperationPlace DA-FS200 Finisher Finisher ModeFinisher/Exit Guide Unit Platen Face-UpPull out the tape Reinstall the Staple Cartridge #Open the Staple Cover Sheet Paper Tray Problem SolvingAdding Paper J Slowly pull the Waste Toner Box Replacing the Toner Cartridge and Waste Toner Box ?Open the Front Cover Straight outShake the new Toner Cartridge Install the new Toner CartridgeInstall a new Waste Toner Box WellCopier Removing a Misfed PaperPaper Misfeed Locations Finisher Paper Feed Unit Finisher Remove the misfed paper Paper Transport AreaPush the latch to open the cover Close the cover by pushingPaper Entry Area Open the Right CoverAutomatic Duplex Unit ADU Close the Right CoverSystem Console ADF/i-ADF #Lift up the ADF Input Tray Check TroubleshootingBefore Calling Service ActionMarked Copies As a rule, clean weeklyLight Copies Platen CoverReplacing the Battery Specifications DP-2500/3000 Copier3rd/4th Paper Feed Module DA-DS200/205/210/215 ADF DA-AS200, i-ADF DA-AR250Bin Finisher DA-FS200 DA-AS200 DA-AR250Options and Supplies Part Name RemarksFor Fax For PrinterWarranty
Related manuals
Manual 187 pages 29.21 Kb