Panasonic VL-GM201A installation and operation guide Technical data about this product

Page 30

General Information

Technical data about this product

Monitor station

Power supply:

24 V DC

Current consumption:

Standby: Approximately 37 mA

 

At operation: Approximately 420 mA

Dimensions:

Approximately height 136 mm x width 136 mm x depth 32 mm

 

(53/8" x 53/8" x 11/4")

Mass (Weight):

Approximately 350 g (0.77 lb.)

Operating environment:

0 °C to 40 °C (32 °F to 104 °F), Up to 90% RH

 

(Relative Humidity) non condensing

Installation method:

Wall mount (Wall mount bracket included)

External material:

Flame retardant ABS resin (panel: acrylic resin)

Note:

LTo connect to a door opener, make sure the door opener is:

Normal open (Low active)

Less than 30 V AC (1 A), 24 V DC (1 A)

AC adaptor (Part number: PFAP1014)

Power supply:

100 V 240 V AC, 50 Hz / 60 Hz

Output voltage:

24 V DC

Output current

2 A

Dimensions:

Approximately height 120 mm x width 60 mm x depth 35 mm

 

(43/4" x 23/8" x 13/8")

Mass (Weight):

Approximately 310 g (0.68 lb.)

Operating environment:

0 °C to 40 °C (32 °F to 104 °F), Up to 90% RH

 

(Relative Humidity) non condensing

Note:

LDesign and specifications are subject to change without notice.

LThe pictures and illustrations in these instructions may vary slightly from the actual product.

30

Image 30
Contents Installation and Operation Guide Thank you for purchasing a Panasonic Single Monitor StationImportant Information Important safety instructions Important InformationAdditional safety information For best performance Included items QuantityOptional item information Compatible PBXsDoor station*1 VL-GC001A, VL-GC002A Desktop stand VL-GT001A Location of controls Front view Side view Rear viewAnswer switch Talk indicatorRinger Volume switch PBX Mode switchBefore installation Standard installation position of the monitor stationWiring schematic diagram Power cable/wire type and distanceInstalling the monitor station Introduction and Installation Introduction and Installation Power cord To attach the AC adaptor and the DC terminal to a wall Introduction and Installation To attach the wires To attach the power cable Monitor station DC terminalPower cable cross section 12 mm CorrectUsing the desktop stand Optional Turning PBX Mode switch ON/OFF Using the Unit Connecting to a PBX Answering a door call using the monitor station Available answer modesPush mode Push to talk mode Using the Unit Monitoring the outside Monitor Bright TalkOpening a door door opener DoorTroubleshooting Problem Cause and solutionCleaning Important informationTechnical data about this product FCC and Other Information For your future reference Panasonic Puerto Rico, IncCopyright