Panasonic VL-GM201A installation and operation guide FCC and Other Information

Page 31

General Information

FCC and Other Information

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)This device may not cause harmful interference.

(2)This device must accept any interference received, including interference that may cause undesired operation.

CAUTION:

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this device.

NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

31

Image 31
Contents Thank you for purchasing a Panasonic Single Monitor Station Installation and Operation GuideImportant Information Important Information Important safety instructionsAdditional safety information For best performance Quantity Included itemsCompatible PBXs Optional item informationDoor station*1 VL-GC001A, VL-GC002A Desktop stand VL-GT001A Front view Side view Rear view Location of controlsPBX Mode switch Talk indicatorRinger Volume switch Answer switchStandard installation position of the monitor station Before installationPower cable/wire type and distance Wiring schematic diagramInstalling the monitor station Introduction and Installation Introduction and Installation Power cord To attach the AC adaptor and the DC terminal to a wall Introduction and Installation 12 mm Correct To attach the power cable Monitor station DC terminalPower cable cross section To attach the wiresUsing the desktop stand Optional Turning PBX Mode switch ON/OFF Using the Unit Connecting to a PBX Available answer modes Answering a door call using the monitor stationPush mode Push to talk mode Using the Unit Monitor Bright Talk Monitoring the outsideDoor Opening a door door openerProblem Cause and solution TroubleshootingImportant information CleaningTechnical data about this product FCC and Other Information Panasonic Puerto Rico, Inc For your future referenceCopyright