Part names and functions, LED indicator

Setup

Part names and functions

C D E

G H I

Speaker

Indicator

Green, lit

Green, blinking

Alternating: Green, blinking Yellow, blinking

Red, lit

Red, blinking quickly

Yellow, lit

Yellow, blinking

Yellow, blinking quickly

Status

Normal operation, connected to

wireless router*1

Registration mode

Hub is starting up (cannot be used yet)*2

Security system is armed

Security system was triggered

Initial setup required

Initial setup in progress, mobile device connected

Initial setup is starting

LED indicator

DC jack

LINE jack

MWi-Fi SETUPN

Used when performing initial setup. microSD card slot

Used when inserting a microSD card. Remove the label when inserting.

M HANDSET/LOCATORN

Used when registering a handset. You can also press this button to locate a misplaced handset.

M CAMERAN

Used when registering a camera.

M OTHER DEVICEN

Used when registering a sensor or smart plug.

LED indicator

You can use the LED indicator to confirm the hub’s status.

Indicator		Status
Off		No power, or LED
		indicator is turned
		off*1

*1 You can configure the hub so that its LED

indicator does not light during normal operation. For more information, refer to the User’s Guide (page 15).

*2 It may take some time for the hub to finish starting up.

Connections

Insert the AC adaptor plug firmly into the DC jack.

Secure the AC adaptor cord by wrapping it around the hook.

Connect the AC adaptor to the power outlet.

Insert the telephone line cord into the LINE jack and a single-line telephone jack (RJ11C) until you hear a click. DSL/ADSL service users only: Connect your DSL/ADSL filter (not supplied).

Outdoor Camera (KX-HNC600) or Indoor Camera (KX-HNC200) users only: Remove the label covering the card slot and then insert the microSD card (not supplied) into the slot with the notched corner (1) facing upwards (2) until it clicks into place.

10For assistance, please visit www.panasonic.com/support