Del

The external display does

If the external display does not support the power saving function, it may not work nor-

not work normally.

mally when the computer enters the power saving mode. Turn off the external display.

Operate the following steps.

A Restart the computer and press

while [Panasonic] boot screen is dis-

The cursor cannot be con-

played.

trolled properly.

B Set [GPS] to [Disable] in the sub-menu of [Serial and Parallel Port Settings] in the

[Advanced] menu of the Setup Utility.

C Press

F10

and select [Yes] at the conﬁrmation message, and press

The computer will restart.

D Log on to Windows as an administrator.

E Click

(Start) and input “c:\util\drivers\gps\GPSVista.reg” in [Start Search], and

press

F Click [Yes], click [Yes], and click [OK].

Then restart the computer.

G Press

while [Panasonic] boot screen is displayed.

H Set [GPS] to [Enable] in the sub-menu of [Serial and Parallel Port Settings] in the

[Advanced] menu.

I Press

F10

and select [Yes] at the conﬁrmation message, and press

Touch Pad / Touchscreen (only for model with touchscreen)

The cursor does not work.	When using the external mouse, connect it correctly.
	Restart the computer using the keyboard.
	Press	and press	two times, and press	to select [Restart] and press		.
					Enter

	Press	,	U	, and	R	to select [Restart].
	If the computer does not respond to keyboard commands, read “No response”
	( page 26).
Cannot input using the touch	Set [Touch Pad] to [Enable] in the [Main] menu of the Setup Utility.
pad.	The drivers for some mice may disable the touch pad. Check your mouse’s operating instructions.
<Only for model with touch screen>
Cannot input using the touchscreen.	Set [Touchscreen Mode] to [Auto] or [Tablet] in the [Main] menu of the Setup Utility.
	Set [Touchscreen Mode] to [Auto] or [Touchscreen Mode] in the [Main] menu of the Setup
	Utility.
Cannot point the correct posi-	Perform the touchscreen calibration ( page 15).
tion using the included stylus.
Reference Manual

The Reference Manual is	Install Adobe Reader.
not displayed.	A Log on to Windows as an administrator.
	B Click		(Start) and input “c:\util\reader\Setup.exe” in [Search programs and ﬁles]
	then press Enter.
	C Update Adobe Reader to its latest version.
	If your computer is connected to the internet, start up Adobe Reader and click [Help]
	- [Check for Updates...].
	B Click [start] - [Run], input [c:\util\reader\Setup.exe], then click [OK].
	C Update Adobe Reader to its latest version.
	If your computer is connected to the internet, start up Adobe Reader and click [Help]
	- [Check for updates now].

Troubleshooting