Panasonic CF-28 Series Reinstalling Software, Before Reinstallation, Preparing

Page 24

Reinstalling Software

Before Reinstallation

Preparing

You will need the followings:

Product Recovery CD-ROM

If it was necessary to create BACKUP DISKS ( page 13), you will need the BACKUP DISKS (e.g., FIRSTAID FD) and the floppy disk drive.

The optional CD drive (Confirm the latest information on optional products in catalogs, etc.)

Mount the CD drive in the multimedia pocket. (Refer to the Operating Instructions of the CD drive for details.)

The operation of reinstallation takes about 20 - 30 minutes.

Important

Save all important data. If reinstallation is carried out, all data existing prior to the installation will be lost. The reinstal- lation will return the computer to close to the conditions at time of purchase.

Before the reinstallation procedure, remove all peripherals (except for the CD drive and the floppy disk drive). Be sure the AC adaptor is connected until the reinstallation procedure is completed.

Troubleshooting

Reinstalling

CAUTION

If data on your hard disk is compressed, the data should be uncompressed.

1Turn the computer off and set the optional CD drive in the multimedia pocket, and then turn the computer on.

2When the message [Press F2 to enter SETUP] is displayed,

press F2 and then run the Setup Utility.

If the password has been set, enter the Supervisor Pass- word.

3Write down all of the contents of the Setup Utility and

then press F9 .

At the confirmation message, select [Yes] and press Enter .

4 Select [Boot] menu, then select [CD Drive] and press F6 until [CD Drive] is at the top of the [Boot] menu.

5Place disk number one of the recovery CDs into the CD drive.

6Press F10 .

At the confirmation message, select [Yes] and then press Enter . The computer will reboot, and the License Agreement screen should appear. Select [1. Yes, I agree to

the provisions above and wish to continue!].

7Dual OS

At the screen for the selection of the operating system, select either Windows 2000 or Windows XP.

You can reinstall only the initially selected operating sys- tem.

8This screen should appear.

Windows 2000

----------------------------------------------------------------

Select a number

----------------------------------------------------------------

1. Restore Windows(R) 2000 Professional to the whole HDD*

2. Restore Windows(R) 2000 Professional to the first partition

3. End

----------------------------------------------------------------

Windows XP

----------------------------------------------------------------

Select a number

----------------------------------------------------------------

1. Restore Windows(R) XP Professional to the whole HDD*

2. Restore Windows(R) XP Professional to the first partition

3. End

----------------------------------------------------------------

* Dual OS : 1. Restore the whole HDD to factory default

9Make a selection from the menu.

To restore all contents of the hard disk to factory de- fault, including the partition setting(s): Select [1].

To reinstall Windows 2000/Windows XP to the first par- tition to factory default: Select [2].

In such cases, the initial partition size must be 4GB or more of the hard disk size. Reinstallation can- not be performed with a small partition size.

NOTE

If "The program has detected an error 110 on the par- tition starting at sector xxxxxxxx on disk1." is dis- played, select [Yes].

24

Image 24
Contents Operating Instructions CF-28 SeriesIntroduction Illustrations and Terminology in this ManualCopyright Disclaimer TrademarksRead Me First For U.S.ARead Me First For CanadaIndustry Canada IC Notice for modem Lithium Battery PrecautionsPeripherals CablesPrecautions Battery Pack When Using Peripheral DevicesWhen Disposing of or Transferring Ownership of This Device Saving Data on the Hard DiskSaving Data on Floppy Disks Computer VirusesMaintenance Usage EnvironmentHandling Touch Pad Areas excluding the displayInsert the battery pack First-time OperationConfirm the inclusion of all parts Connect your computer to a power outlet Power Indicator Power SwitchFirst-time Operation Open the displaySetup Windows Select the Operating SystemOnly for models with 13.3 type LCD Only for models with touchscreenResetting the password This concludes the first-time use operation guidelinesCreate Backup Disks for Reinstallation Eject ButtonIf security indicator is displayed Starting Up/Shutting DownStarting Up Will StartLog on to Windows Select your applicationShutting Down power off your computer Starting Up/Shutting DownConfirm shut down Restarting your computer without shutting downTouch Pad Basic Operation Work SurfaceMove the tip of your finger lightly over SurfaceReference Manual List of Error Codes List of Error Codes Dealing with Problems Summary Starting UpDealing with Problems Summary DisplayShift Battery Indicator Fast User Switching function Windows XPReference Manual Shutting downReinstalling Software Before ReinstallationReinstalling PreparingCtrl + Alt + Del Limited USE License Agreement Contrat de licence d’usage limité LicenceTermes, clauses et conditions Names and Functions of Parts Microphone Jack External Keyboard/Mouse Port USB PortHeadphone Jack Hard Disk DriveSpecifications Main SpecificationsPhysical Dimensions W x H x D SoftwareLimited Warranty Panasonic Computer and Peripherals Limited Warranty Memo Page Panasonic Computer Solutions Company Panasonic Canada Inc