Panasonic PT-50LC13 Power on and OFF, Initial Setup, If using Cable Box, DSS Receiver, or VCR

Power ON and OFF

Initial Setup

First, check the connection of the Plug to the Wall Outlet and the Antenna/Cable to the RF in Terminal. (PP. 12-14.)

If using Cable Box, DSS Receiver, or VCR,

•Turn on Cable Box.

•Turn off DSS Receiver, or VCR.

Press the POWER button to turn the projection display on.

(Refer to page 23 for “Turning the Power ON and OFF”.)

Automatic Channel Setting is performed.

CH AUTO SET PROCEEDING

Note:

To cancel AUTO SET in progress, press the

SWAP button.

Case 1

When setup is complete, the lowest channel picture appears.

Case 2

If setup is incomplete, the following screen appears. Check connection of Antenna/Cable to the RF in Terminal, then try Automatic Channel Setting again. (PP. 26-27)

NO CH FOUND

PLEASE CHECK ANTENNA

CABLE CONNECTION THEN

PRESS ACTION KEY AGAIN

Note:

When the unit is turned on for the first time, Automatic Channel Setting is performed.

22 For assistance, please call : 1-888-VIEW PTV(843-9788)