Panasonic pt-ae900e manual Adjusting the position

Adjusting the position

#Press the MENU button to display the menu screen.

$Select the “POSITION” menu from the main menu, and then press the ENTER button.

%Press the F or G button to select an item.

&Press the I or H button to adjust the value or change the setting. For items with selective setting or a bar scale, the individual adjustment screen will be displayed. Press the F or G button to switch the item. When the input signal is from a PC, first select “AUTO SETUP” and then press the ENTER button to initiate automatic positioning. If the optimum setting is not obtained when “AUTO SETUP” is carried out, adjust the other items.

NOTE:

BIf signals with a dot clock

frequency of 100 MHz or higher

are being input, interference

may not be completely

eliminated when the “DOT

CLOCK” and “CLOCK PHASE”

adjustments are carried out.

BWhen YPBPR signals are being

input, “CLOCK PHASE” can be

adjusted only when 1 125

OVER SCAN

[525p (480p), 750 (720)/60p, 750 (720)/50p, 1 125 (1 080)/60i, 1 125 (1 080)/50i, 1 125 (1 080)/24p signals for YPBPR and HDMI signals]

Set to “OFF” when some letters or parts of a projected image not visible

When an S-VIDEO/VIDEO/SCART signal is being input

When a HDMI signal is being input

When a YPBPR signal is being input

When a PC signal is being input

48-ENGLISH

Horizontal position (H-POSITION)

To move the picture to the left: I button

To move the picture to the right: H button

Vertical position (V-POSITION)

To move the picture down: I button

To move the picture up: H button

DOT CLOCK

(PC only)

Periodic striped pattern interference (noise) may occur when a striped pattern such as the one below is projected. If this happens, press the

Ior H button to adjust so that any such noise is minimised.

CLOCK PHASE

(PC/YPBPR only)

Adjust the “DOT CLOCK” setting first before carrying out this adjustment. Press the I or H button to adjust so that the noise level is least noticeable.

(1 080)/60i, 1 125 (1 080)/50i,

1 125 (1 080)/24p, 750

(720)/60p or 750 (720)/50p

signals are being input.

ASPECT

The aspect ratio can be selected. Refer to page 30 for details.

WSS

ON

When the device connected to SCART is turned on, the input select setting will be switched to SCART automatically, and “ASPECT” will also be set automatically.

When WSS (Wide Screen Signalling) is detected from PAL or 625i(576i) YPBPR signals, the aspect ratio will also be switched automatically.

OFF

When SCART signals are being input, the input select setting and “ASPECT” will not be set automatically.

WSS will not be detected from PAL or 625i(576i) YPBPR signals.

around the edges of the image.

KEYSTONE

When either the projector or the
screen is tilted, the keystone
distortion will affect the image. If the
projected image contains keystone
distortion, follow the procedures in
the table to correct any keystone
distortion. (Vertical keystone
distortion correction only.)
		settingsand
Picture	Press the F
condition	Operation
	button.	Adjustments
	Press the G
	button.

NOTE:

BVertical keystone distortion can be corrected to ±30° of the angle of tilt. However, the greater the correction amount, the more the picture quality will deteriorate, and the harder it will become to achieve a good level of focus. To obtain the best picture quality, set up the projector and screen in such a way that the amount of

ENGLISH-49