Adjusting the position
When the input signal is RGB, first press the AUTO SETUP button to initiate automatic positioning.
If the optimum setting is not obtained when AUTO SETUP is carried out, adjust by the following procedure.
Use the F and G buttons on the projector or remote control unit to select an item, and then use the I and H buttons to change the setting for that item.
For items with bar scales, press the ENTER button or the I or H buttons to display the adjustment screen, and then use the I or H buttons to make the adjustment.
When an RGB/YPBPR signal is being input
POSITION
POSITION |
|
DOT CLOCK | 32 |
CLOCK PHASE | 16 |
ASPECT | 4:3 |
RESIZING | ON |
FRAME LOCK | OFF |
STANDARD |
|
SELECT 
ENTER 
RETRN
When an
POSITION
POSITION
ASPECT 
4:3
RESIZING 
ON STANDARD
SELECT 
ENTER 
RETRN
POSITION
Moves the picture position.
Press the ENTER button to display the POSITION screen.
Press the I or H buttons to move the picture horizontally.
Press the F or G buttons to move the picture vertically.
POSITION H 64
V32
DOT CLOCK
(RGB only)
Periodic striped pattern interference (noise) may occur when a striped pattern such as the one below is projected. If this happens, use the
Iand H buttons to adjust so that any such noise is minimised.
CLOCK PHASE
(RGB/YPBPR only)
Adjust the DOT CLOCK setting first before carrying out this adjustment. Use the I and H buttons to adjust so that the noise level is least noticeable.
NOTE:
BIf signals with a dot clock frequency of 100 MHz or higher are being input, interference may not be completely eliminated when the DOT CLOCK and CLOCK PHASE adjustments are carried out.
ASPECT
This setting is only for an
ASPECTAUTO
[
4:3
[�
16:9
[�
S4:3
AUTO
When an S1 video signal is input to the
4:3
The input signal is projected without change.
16:9
The picture is compressed to a ratio of 16:9 and projected.
When a squeezed signal is being input. (The projected image is contracted vertically)
[
S4:3
The size of the input signal is compressed to 75% and projected. (This is useful for projecting a picture with a 4:3 aspect ratio onto a 16:9 screen.)
When a 4:3 signal is being input
[
When using the 16:9 screen
S1 video signals
BS1 video signals are a type of video signal with an aspect ratio of 16:9 which include a detector signal. This detector signal is output by some sources such as
Adjustments and settings
|
|