Location and function of each part
Projector <Top, right and front>
# $ %
Projector <Back and bottom> |
|
| Preparation |
' | # | $ | |
|
|
|
+
*
)
&
'
(
& |
% |
#Projector control panel(Top) (page 14)
$Zoom ring (page 23)
%Focus ring (page 23)
&Security lock
This can be used to connect a
Kensington Technology Group ACCO Brands Inc.
2855 Campus Drive
San Mateo, CA 94403 USA Tel
Fax
http://www.gravis.com/
NOTE:
BInformation given above may be changed in future.
'Leg adjuster buttons(L/R) (page 23)
These buttons are used to unlock the front adjustable legs. Press to adjust the angle of tilt of the projector.
(Lens cover
)Projection lens
*Remote control signal receptor (page 21)
+Speaker
#Connector panel cover (page 16)
$Air outlet port
Do not cover this port.
%Front adjustable legs(L/R) (page 23)
&Air inlet ports, Air filter Do not cover these ports.
'Lamp unit holder (page 50)
WARNING
Do not place your hands or other objects close to the air outlet port.
BHeated air comes out of the air outlet port. Do not place your hands or face, or objects which cannot withstand heat close to this port, otherwise burns or damage could result.
NOTE:
BDuring projection of an image, the cooling fan will operate, emitting a small noise as it operates. Turning the lamp on or off will cause this noise to increase a little.
BBy using the OPTION2 menu to set “LAMP POWER” to “LOW”, the operating sound of the fan can be reduced. (Refer to page 43.)