Projector control panel <Top> |
| Menu | ||
|
|
|
| operation |
# $ % & |
|
|
| <on connector |
| ' | ( | panel:page 16> | |
| * | |||
|
|
|
| |
|
|
| ) | +, |
Remote control unit |
|
|
| |
' |
|
|
|
|
) | POWER | INPUT | ( | |
| ||||
|
|
|
| |
|
| VIDEO | RGB |
|
+ |
|
|
| * |
|
|
|
| |
| AUTO |
| MENU |
|
| SETUP |
|
| |
|
|
| , | |
- |
|
|
| |
|
|
|
| |
|
| ENTER |
|
|
/ |
|
|
| . |
|
|
|
| |
| FREEZE |
| SHUTTER |
|
|
|
|
| 0 |
|
| STD |
|
|
| VOLUME |
| D.ZOOM |
|
|
| INDEX |
|
|
|
| WINDOW |
|
|
1 |
| PROJECTOR |
| 2 |
%TEMP indicator (page 47)
This indicator illuminates if an abnormally high temperature is detected inside the projector or around it. If the temperature rises above a certain level, the power supply will be turned off automatically and the indicator will illuminate or flash.
&Power indicator (page 25)
This indicator illuminates red when the MAIN POWER switch is turned on (standby mode), and illuminates green when the power is turned on and a picture starts to be projected.
'POWER button (pages 22 and 24)
(Input select (INPUT, VIDEO, RGB) buttons
(page 23)
)AUTO SETUP button (pages 23 and 26)
If this button is pressed while a picture is being projected, the projection settings will be adjusted automatically in accordance with the signal being input. In addition, the angle of tilt of the projector will be automatically detected and adjusted in order to correct any keystone distortion.
*MENU button |
(pages 30 and 32) |
This button is used to display the |
menu screens. When a menu |
screen is being displayed, this |
button can be used to return to a |
previous screen or to clear the |
,ENTER button (page 32)
This button is used to accept and to activate items selected in the
-FREEZE button (page 27)
This button is used to momentarily freeze projection so that a still picture is displayed.
.SHUTTER button (page 27)
This button is used to momentarily turn off the picture and sound.
/VOLUME +/- buttons (page 28)
These buttons are used to adjust the volume of the sound output from the projector’s
0STD (standard) button (page 33)
This button is used to reset the projector adjustment values to the factory default settings.
1INDEX WINDOW button (page 29)
This button can be used to split the image projection area into a
still image and a moving image.
2D.ZOOM +/- buttons (page 28)
These buttons are used to enlarge the projected image.
Preparation
#RGB INPUT indicator (page 25)
This indicator shows whether a signal is being input to the RGB input connectors (RGB 1 IN/RGB 2 IN). When an input signal is detected, the indicator illuminates.
$LAMP indicator (page 48)
This indicator illuminates when it is time to replace the lamp unit. It flashes if a circuit abnormality is detected.
screen. |
+Arrow (FGI and H) buttons (page 32)
These buttons are used to select and adjust items in the menu screens.