Panasonic PT-LB78E manual Read this first, Minimum required setting screen

Read this first

Minimum required setting screen

When you start the projection for the first time or after the projector is initialised, the minimum required setting screen for projection will be displayed.

LANGUAGE

Select the required language setting.

LANGUAGE

ENGLISH

PLEASE SELECT LANGUAGE

SELECT

ENTER

Press F G I H buttons of the remote control or control panel on the projector to highlight the required language, and press the ENTER button to proceed to the next setting.

OPTION

Select the current projection method and fan speed setting. If you need return to the previous setting, press the RETURN button.

OPTION

INSTALLATION FRONT/DESK

ALTITUDELOW

SWITCH TO HIGH ALTITUDE MODE "HIGH" IF OVER 1400m(4593Ft).

RETURN

SELECT

ENTER

INSTALLATION

Press I H buttons of the remote control or control panel on the projector to select the required installation method. Press G to proceed to the ALTITUDE setting.

FRONT/DESK	Setting on a desk/floor and
	projecting from front
FRONT/CEILING	Mounting in the ceiling and
	projecting from front
REAR/DESK	Setting on a desk/floor and
	projecting from rear
REAR/CEILING	Mounting in the ceiling and
	projecting from rear

ALTITUDE

If you use the projector at high elevation, the ALTITUDE setting need to be HIGH to set the fan speed high. Press I H to select the required option. If you need to return to the INSTALLATION, press F.

LOW	The fan speed is low.
HIGH	The fan speed is high.

NOTE:

•At 1 400 - 2 700 m (4 593 - 8 858 ft) sea level, the setting must be HIGH.

•The loudness of fan noise depends on the ALTITUDE setting.

Preparation

Press the ENTER button to start the projection.

Once you finish the minimum requirement setting, it will not be displayed again unless the projector is initialised. See “INITIALIZE ALL” on page 38.

You can change each settings in the main menu. See “Menu Navigation” on page 29.

ENGLISH - 13