Panasonic PT-LB78E manual Projecting an image, Selecting the input signal, Positioning the image

Projecting an image

Selecting the input signal

1. Switch on the connected devices.

Press the play button of the required device.

2.Detect the input signal automatically.

3.Switch the aspect ratio automatically.

NOTE:

•If the SIGNAL SEARCH in OPTION menu is deactivated, select the required input method by pressing the INPUT SELECT buttons of the remote control or the INPUT SELECT button of the projector several times. See “SIGNAL SEARCH” on page 37, “Switching the input signal” on page 26 or “INPUT SELECT button” on page 14.

•See “ASPECT” on page 34.

Basic Operation

Positioning the image

1.Place the projector at the right angle from the screen.

Screen

2. Adjust the vertical angle of the projector.

Press the front leg adjuster buttons and adjust the vertical angle.

See “Front leg adjusters and throwing angle” on page 18.

3. Open the Zoom-Focus ring cover.

See “Zoom-Focus ring cover” on page 14.

4.Turn the zoom and focus rings to adjust the projected image.

You can confirm the adjusted effect with the TEST PATTERN in OPTION menu. See “TEST PATTERN” on page 38.

Focus ring

Zoom ring

5. Close the Zoom-Focus ring cover.

See “Zoom-Focus ring cover” on page 14.

NOTE:

•Do not touch the air exhaust port as this may cause burns or injury.

•If keystone distortion occurs, see “KEYSTONE” on page 34.

•When you adjust the zoom after adjusting the focus, you may need to adjust the focus of the image again.

ENGLISH - 24