Panasonic PT-LB10VE, PT-LB10SE, PT-LB10E Adjusting the position, Position, DOT Clock, Clock Phase

Adjusting the position

When an RGB signal is being input, press the AUTO SETUP button first to initiate automatic positioning. If the optimum setting is not obtained when “AUTO SETUP” is carried out, adjust by the following procedure.

Press the F or G button on the projector or remote control unit to select an item, and then press the I or H button to change the setting. For items with bar scales, press the ENTER button or the I or H button to display the adjustment screen, and then press the I or H button to make the adjustment.

When an RGB/YPBPR signal is being input

POSITION

POSITION
DOT CLOCK	32
CLOCK PHASE	16
ASPECT	4:3
RESIZING	ON
FRAME LOCK	OFF
STANDARD

SELECTENTER RETRN

When an S-VIDEO/VIDEO signal is being input

POSITION

POSITION

ASPECT 4:3

RESIZING ON STANDARD

SELECTENTER RETRN

POSITION

Moves the picture position.

Press the ENTER button to display the “POSITION” screen.

Press the I or H button to move the picture horizontally.

Press the F or G button to move the picture vertically.

POSITION H 64

V32

DOT CLOCK

(RGB only)

Periodic striped pattern interference (noise) may occur when a striped pattern such as the one below is projected. If this happens, press the

Ior H button to adjust so that any such noise is minimised.

CLOCK PHASE

(RGB/YPBPR only)

Adjust the “DOT CLOCK” setting first before carrying out this adjustment. Press the I or H button to adjust so that the noise level is least noticeable.

NOTE:

BIf signals with a dot clock frequency of 100 MHz or higher are being input, interference may not be completely eliminated when the “DOT CLOCK” and “CLOCK PHASE” adjustments are carried out.

40-ENGLISH