# restore ?

Appendix A Upgrading Your CSS Software

Upgrading Your CSS

If you did not configure a default FTP record before starting the upgrade script, the script prompts you to configure one. You can either:

•Allow the CSS to automatically configure a record to the server containing the ADI.

•At the prompts, manually configure the FTP record by entering the FTP server information where you copied the upgrade ADI.

When a default FTP record is configured, information similar to the following appears during the upgrade:

Current Version:sg0710002 (Build 2)

*** You must remove an installed version to upgrade. ***

Attempting to delete sg0710001

archive running-config startup-config

Attempting ftp of sg0710002.adi:

#copy ftp DEFAULT_FTP ${new_version_adi} boot-image Copying (-) 57,241,012

Completed successfully. #(config-boot)#

unpack ${new_version_adi} Unpacking(/) 99% (config-boot)#

setting primary boot-file sg0710002

rebooting

The CSS automatically performs a flash upgrade, if necessary, and then boots the new image.

4.After you upgrade the software in a CSS 11506 that contains a passive SCM, use the passive sync command in boot-config mode (or the passive sync macro command) immediately after upgrading your CSS software to synchronize the boot configurations on the redundant SCMs. Refer to Chapter 1, Logging In and Getting Started, the “Configuring a Boot Configuration Record for the Passive SCM” section.

5.Use the restore command to restore the startup-config file, custom scripts, and user-profile files previously archived in the CSS archive directory. To see a list of files in the archive directory, enter:

	Cisco Content Services Switch Adminisitration Guide
A-6	78-13885-03