Zebra Technologies RXi4 manual Preparing the Printer for Use

Page 6

6

Preparing the Printer for Use

7.Raise the media door.

8.Load media into the printer (see Load Media on page 9).

9.When using thermal transfer media, load ribbon into the printer (see Load Ribbon on page 16). Direct thermal media does not use ribbon.

10.Turn on (I) the printer.

The printer boots up and performs a self-test. PRINTER READY displays when the printer is ready to print.

P1008806-002

Xi4™/RXi4™ Quick Reference Guide

3/8/10

Image 6

Contents Xi4/RXi4 Quick Reference Guide Printer ComponentsControl Panel LCDCalibrates the printer for the following To set up the printer, complete these steps Preparing the Printer for UsePreparing the Printer for Use Preparing the Printer for Use Preparing the Printer for Use Xi4 RXi4 Load Media To load roll media in Tear-Off mode, complete these steps110Xi4/R110Xi4 600 dpi 110Xi4/R110Xi4 200 dpi and 300 dpi Other Xi4 Models Load Media Ribbon OUT error Load Media Load Media Load Ribbon To load ribbon, complete these stepsIf… Then… Does your printer have a ribbon dancer assembly? Then Load Ribbon Load Ribbon Remove Used Ribbon To remove used ribbon, complete these steps