INSTALLATION OF MEDIA
The following details media installation:
1.Turn unit off.
2.Squeeze the two finger grips on either side of the media compartment cover. Rotate the top back to reveal the paper compartment.
3.Drop a new roll of paper into the compartment. Media should feed from the top of the roll and the roll should fit between the edge guide and the right hand wall.
The inner core on the media roll should be Ø.75” [ 19 mm] or larger to prevent the roll from jamming.
4.If using narrow media, adjust the edge guide by snapping it into the desired slots on the printer body. Insure the media can turn freely.
Use the table below as a guide for allowable media widths:
Cameo PEP Media Widths1
1.47(37.3 mm)
1.60(40.64 mm)
1.72(43.7 mm)
1.85(47.0 mm)
1.97(50.0 mm)
2.10(53.3 mm)
2.22(56.4 mm)
2.35(59.7mm)
2.47(62.7 mm)
2.6066.0 mm)
2.72(69.1 mm)
2.85(72.4 mm)
2.97(75.4 mm)
3.10(78.7 mm)2
1.All dimensions 2002 2002 mm]
2.This width available only with edge guide removed.
5.Close the cover while holding the free end of the media roll.
6.Insure the cover is securely latched before begin- ning to print.
10 |