Chargers

Conditioning Battery Packs

IMPORTANT

Cameo batteries must be cycled several times before maximum capacity is realized.

A battery is ”cycled” by fully charging it, then fully discharging it through normal use.

Listed below are the specifications for the Cameo PEP chargers:

UCN72-4: (p/n series AC15482-tab)

Designed to charge up to four batteries simulta- neously. Battery packs may be charged separately or while plugged into the printer. Typical charge time is 90 minutes. Switch selectable 110/220 V.A.C. input voltage. Supplied with line cords

compatible with most international standards.

Do not attempt to charge batteries with the UCN72-4 Charger while printing. Attempting to print while charging batteries can result in unreli-

able charging.

Part numbers will vary depending on specific coun- try of use. Consult factory for complete part num- bers.

UC72N: (p/n series AT15244-tab)

A wall mounted single charger . Universal 110 to 230, 50-60 Hz. VAC input. Multiple plug configura- tions comply with most international standards.

Do not attempt to charge batteries with the

UC72N Charger while printing. Attempting to print while charging batteries can result in unreliable

charging.

Part numbers will vary depending on specific coun- try of use. Consult factory for complete part num- bers.

UMAN-PEP