Zebra Technologies Portable Encoding Printer Reduced battery charge life, Status light always on

Page 21

•Invalid label format or command structure — use Hex Dump Mode for troubleshooting.

Reduced battery charge life:

•Recondition (cycle) battery.

•Damaged battery-replace.

•Check battery date code: if one to two years old, short charge life may be due to normal aging.

Status light flashing and beeper chimes:

•No application: reload program.

•If using wireless communications: normal indication while data is being received.

Status light always on:

•Check media is loaded and media compartment cover is closed and latched

Communication Error:

•Check media is loaded, media compartment cover is closed and latched, and error light is off.

•Check baud rate.

•Replace cable to terminal.

Card will not Read/Write:

•Ensure a smooth sliding motion is used and that card remains seated in the MCE slot.

Never use any sharp objects on the printer

mechanism as it could damage the print head. Use only alcohol, the supplied cleaning pen and

/or a cotton swab for cleaning the printer.

21

UMAN-PEP

Image 21

Contents Portable Encoding Printer Users ManualProduct Improvements Proprietary StatementFCC Compliance Statement Canadian Compliance StatementCONTENTS Communications Battery Latchfor optional IrDA communicationsPublication.pdf filename INTRODUCTIONCONTROLS Keypad FunctionsSelf Test Removing and Replacing Battery Packs BATTERIES AND CHARGINGChargers Conditioning Battery PacksSafety Warnings Low Battery ShutdownINSTALLATION OF MEDIA INSTALLATION OF MEDIA IN THE CAMEO PEP Cleaning the print head MAINTENANCECleaning the platen print roller Cleaning the Media SensorPrint Head CLEANING THE CAMEO PEPMedia Sensor PlatenMAGNETIC CARD ENCODER MCE Reading CardsEncoding Cards USING THE CAMEO PEP MAGNETIC CARD ENCODER Stripe faces this waySlide card in this direction Cable Communications COMMUNICATING TO THE PRINTERLinking a Printer to an IrDA Host IR CommunicationsBluetooth Networking Overview A Typical Bluetooth Connection Sequence Address BDA loaded into its radio module when manu- facturedTroubleshooting Guide TROUBLESHOOTINGNo power Media does not feedCommunication Error Reduced battery charge lifeStatus light flashing and beeper chimes Status light always onAppendices INTERFACE CABLES APPENDIX AINTERFACE CABLES INTERFACE CABLES continued MEDIA SUPPLIES APPENDIX BMAINTENANCE SUPPLIES APPENDIX CPRODUCT SUPPORT APPENDIX DZebra Technologies Europe Limited Zebra TechnologiesPATENT INFORMATION